Download
Share
Print this page
  1. Manuals
  2. Brands
  3. YoYo Manuals
  4. Wireless Router
  5. YOYORouter BE5
  6. Quick start manual

YoYo YOYORouter BE5 Quick Start Manual

High performance combo router
Hide thumbs

Advertisement

Quick Links

Download this manual
High Performance Combo Router BE5
Quick Start Guide
www.yoyomotion.com

Advertisement

loading

Summary of Contents for YoYo YOYORouter BE5

  • Page 1 High Performance Combo Router BE5 Quick Start Guide www.yoyomotion.com...

  • Page 2: Operating Modes

    Wireless WAN Mode if the cabled WAN connection fails. In any of these modes, YOYORouter BE5 can also send and receive SMS messages and make/receive mobile phone calls via a connected telephone. (A SIM supporting these services must be plugged in).
  • Page 3 • To remove the SIM, press gently inwards until you hear a click; the SIM card will then be ejected. Note: A SIM card is not required if the BE5 is to be used in Ethernet WAN Mode only with no phone or SMS.
  • Page 4 Connecting to YOYORouter BE5 Using Ethernet cable (easiest): • Plug in the Ethernet cable to a LAN port and check that the corresponding LAN indicator lights up. YOYORouter’s Wi-Fi network has a network name (SSID) like YOYORouter-07-76. The network name and password are printed on the label on the underside of the device and on the label affixed to the carton in which it was packaged.
  • Page 5 1. Plug in your SIM card and switch on YOYORouter. Allow at least 60 seconds for network scanning. In most cases BE5 self-configures in Wireless WAN mode using default settings. You may need to customize the settings, for example in the following cases: •...
  • Page 6 Setting up YOYORouter BE5 in Ethernet WAN mode 1. Plug in the Ethernet cable (for example from an ADSL modem) to the WAN port and switch on YOYORouter. 2. Connect to YOYORouter, access the status page at http://192.168.1.1 and log in.
  • Page 7 Setting up YOYORouter BE5 in Ethernet WAN Mode with Failover First configure YOYORouter BE5 in Wireless WAN Mode and test the connection. Next, configure YOYORouter BE5 in Cable and test the connection. To enable WAN Mode with Failover, ensure that your SIM Card is inserted and the Ethernet WAN is connected and follow these steps: 1.

  • Page 8: Wi-Fi Configuration Tips

    Wi-Fi Configuration Tips YOYORouter is pre-configured with a default Wi-Fi network name (SSID) and password. The network name and password are printed on the label on the underside of the device and on the label affixed to the carton in which it was packaged. Security is set to WPA-PSK(TKIP) and WPA2-PSK(AES) – devices may connect using either of these.

  • Page 9: Indicator Lights

    Indicator Lights Mobile Service indicators Signal Strength and Roaming Alert Disconnected No signal; no SIM card; Mobile network service is 2G incorrect or missing PIN (GPRS or EDGE) Data transfer over 2G Connected, low signal Connecting Mobile network service is 3G (HSPA/HSDPA/UMTS) Connected, medium signal Data transfer over 3G...
  • Page 10 Important Information Please read this information before using your YOYORouter. REMEMBER THAT YOYOROUTER CONTAINS BOTH A MOBILE BROADBAND (MOBILE PHONE) TRANS- MITTER AND A WI-FI TRANSMITTER. YOU MUST AT ALL TIMES OBEY ALL RESTRICTIONS FOR BOTH OF THESE TRANSMITTER TYPES. Safety and Usage Guidelines •...