Advertisement
2. Outline Procedure
The outline procedure is shown below.
GT11 installation follows.
1) Install the OS.
• Install the communication driver of the PLC connected to the multi-drop connection module.
• Install the communication driver (multi-drop (Slave)) to the GOT.
For details of the installation method, refer to the GT Designer2 Version2 Basic Operation/Data Transfer Manual or GT Designer3 Version1 Screen Design Manual.
- For GT Designer2
(For multi-drop connection module)
- For GT Designer3
(For multi-drop connection module)
2) Make sure that the OS is installed.
Check GT Designer2 or GT Designer3 drive information to know if the OS is properly installed in the GOT.
For details, refer to the GT Designer2 Version2 Basic Operation/Data Transfer Manual or GT Designer3 Version1 Screen Design Manual.
3) Set the communication interface.
• For the multi-drop connection module, set the communication interface in the communication setting with GT01-RS4-M of GT Designer2 or GT Designer3.
• For the GOT, set the communication interface in the Communication Settings of GT Designer2 or GT Designer3.
For details, refer to the GT Designer2 Version2 Basic Operation/Data Transfer Manual or GT Designer3 Version1 Screen Design Manual.
(For GOT)
(For GOT)
- For GT Designer2
(For multi-drop connection module)
- For GT Designer3
(For multi-drop connection module)
4) Download the project data.
For instructions on how to download the project data, refer to the GT Designer2 Version2 Basic Operation/Data Transfer Manual or GT Designer3 Version1 Screen Design
Manual.
5) Connect the cable.
For details of the cable connection, refer to the GOT1000 Series Connection Manual.
(For GOT)
(For GOT)
Advertisement
