Safety Part Information; Prevention Of Electro Static Discharge (Esd) To Electrostatically Sensitive (Es) Devices - Panasonic SA-AK450GCP Service Manual

· No sound is heard when the power is turned on.
· Sound stops during a performance.
The function of this circuitry is to prevent circuitry damage if, for example, the positive and negative speaker connection wires are
"shorted", or if speaker systems with an impedance less than the indicated rated impedance of the amplifier are used.
If this occurs, follow the procedure outlines below:
1. Turn off the power.
2. Determine the cause of the problem and correct it.
3. Turn on the power once again after one minute.
Note :
When the protection circuitry functions, the unit will not operate unless the power is first turned off and then on again.
1.5.

Safety Part Information

Safety Parts List:
There are special components used in this equipment which are important for safety.
These parts are marked by
be replaced with manufacturer's specified parts to prevent shock, fire or other hazards. Do not modify the original design without
permission of manufacturer.
Table 1
Reference No.
S5950
T5950
T5951
Z5950
RL5950
FP5920
FP5940
FP5950
JK5950
2 Prevention of Electro Static Discharge (ESD) to
Electrostatically Sensitive (ES) Devices
Some semiconductor (solid state) devices can be damaged easily by electricity. Such components commonly are called
Electrostatically Sensitive (ES) Devices. Examples of typical ES devices are integrated circuits and some field-effect transistors and
semiconductor "chip" components. The following techniques should be used to help reduce the incidence of component damage
caused by electro static discharge (ESD).
1. Immediately before handling any semiconductor component or semiconductor-equiped assembly, drain off any ESD on your
body by touching a known earth ground. Alternatively, obtain and wear a commercially available discharging ESD wrist strap,
which should be removed for potential shock reasons prior to applying power to the unit under test.
2. After removing an electrical assembly equiped with ES devices, place the assembly on a conductive surface such as aluminium
foil, to prevent electrostatic charge build up or exposure of the assembly.
3. Use only a grounded-tip soldering iron to solder or unsolder ES devices.
4. Use only an anti-static solder remover device. Some solder removal devices not classified as "anti-static (ESD protected)" can
generate electrical charge to damage ES devices.
5. Do not use freon-propelled chemicals. These can generate electrical charges sufficient to damage ES devices.
6. Do not remove a replacement ES device from its protective package until immediately before you are ready to install it. (Most
replacement ES devices are packaged with leads electrically shorted together by conductive foam, aluminium foil or
comparable conductive material).
7. Immediately before removing the protective material from the leads of a replacement ES device, touch the protective material
to the chassis or circuit assembly into which the device will be installed.
Caution
Be sure no power is applied to the chassis or circuit, and observe all other safety precautions.
8. Minimize body motions when handling unpackaged replacement ES devices. (Otherwise harmless motion such as the brushing
in the Schematic Diagrams & Replacement Parts List. It is essential that these critical parts should
Part No.
K0ABLB000003
G4CYAYY00143
G4C2AAJ00005
ERZV10V511CS
K6B1AEA00015
F1 K5D402BLA013
F2 K5D202BLA013
K5G702A00009
K5G702Z00004
K5G402A00025
K2AA2B000011
A2 K2CQ2CA00006
Part name & Description
SW VOLTAGE SELECTOR
MAIN TRANSFORMER
SUB TRANSFORMER
ZENER
POWER RELAY
FUSE
FUSE
FUSE PROTECTOR
FUSE PROTECTOR
FUSE PROTECTOR
JK AC INLET
AC CORD
5
SA-AK450GCP
Remarks