Toyota 2002 Land Cruiser Owner's Manual page 160

WWW.MANUALS.WS
Programming other devices
To program other devices such as home
security systems, home door locks or
lighting, contact your authorized Toyota
dealer for assistance.
Reprogramming a button
R
Individual HomeLink buttons cannot be
erased, however, to reprogram a single
button, follow the procedure "Programming
R
the HomeLink ".
R
(b) Operating the HomeLink
R
To operate the HomeLink , press the ap-
R
propriate HomeLink button to activate the
programmed device. The HomeLink
cator light should come on. The Home-
R
Link continues to send the signal for up
to 20 seconds as long as the button is
pressed.
(c) Erasing the entire HomeLink
memory (all three programs)
To erase all previously programmed codes
at one time, press and hold down the 2
outside buttons for 20 seconds until the
indicator light flashes.
If you sell your vehicle, be sure to erase
the programs stored in the HomeLink
memory.
160
WWW.MANUALS.WS
CAUTION
_
When programming the HomeLink
Universal Transceiver, you may be
operating a garage door or other
device. Make sure people and ob-
jects are out of the way of the
garage door or other device to
prevent potential harm or damage.
_
Do not use this HomeLink
versal Transceiver with any garage
door opener that lacks the safety
stop and reverse feature as re-
quired by federal safety standards.
R
indi-
(This includes any garage door
opener model manufactured before
April 1, 1982.) A garage door open-
er which cannot detect an object
(signaling the door to stop and re-
R
verse), does not meet current fed-
eral safety standards. Using a ga-
rage door opener without these
features increases risk of serious
injury or death.
R
'02 L/C U (L/O 0108)
FCC ID: CB2V94800
CANADA: 1763 102 264
R
This device complies with FCC Rules
part 15. Operation is subject to the fol-
lowing two conditions: (1) This device
may not cause harmful interference, and
(2) this device must accept any interfer-
ence that may be received, including
interference that may cause undesired
R
Uni- operation.
WARNING: This transmitter has been
tested and complies with FCC and
DOC/MDC rules. Changes or modifi-
cations not expressly approved by the
party responsible
could void the user's authority to op-
erate the device.
for compliance