Changing A Flat Tire - Honda 1991 Accord Sedan Owner's Manual

Changing a Flat Tire

Do not attempt to change a tire unless the car is on firm, level
ground and well out of the flow of traffic.
Park the car on a firm, level surface, apply the parking brake, turn
on the hazard warning switch and put the transmission in gear (Park
for automatic).
1. Remove the cover.
2. Remove the jack.
NOTE:
Turn the connector on the end of the jack counterclockwise to
loosen it from its mount.
3. Remove the lug wrench/jack handle and jack handle extension
from the tool bag.
4. Remove the spare tire.
5. Place blocks in front and back of the wheel diagonally opposite
the tire you are changing.
6. Use the lug wrench to loosen the wheel lug nuts counterclock-
wise one-half turn.
On the EX and SE models:
First remove the center cap from the wheel by prying it out with
a common flat screwdriver (not provided in the tool bag).
CAUTION:
Hold the center cap with your hand then pry it off using a rag to
protect the cap and the wheel.
CENTER CAP
TOOL BAG
COMPACT SPARE
COVER
JACK
SCREWDRIVER