Table of Contents
Advertisement
5-4-8 Center Convergence Adjustment
1. Warm up the receiver for at least 20 minutes.
2. Adjust the two tabs of the 4 pole magnets to
change the angle between them. Superimpose
the red and blue vertical lines in the center
area of the screen.
3. Adjust the Brightness and Contrast controls for
a well defined picture.
4. Adjust the two-tab pairs of the 4 pole magnets,
and change the angle between them.
Superimpose the red and the blue vertical
lines in the center area of the screen.
BLUE
BLUE
RED
4-Pole Magnet Movement
5-4-9 Dual Tuner AFT Adjustment
Test Equipment
1. TV Generator (PM5518,PM5418,ETC.)
2. DC VOLTMETER
1.
Connect DC Voltmeter to AFT terminal of TUNER
After selecting P00, input to IF1 terminal of TU002 (38.9 MHz Using PM5518)
2.
After selecting P00, set to 2.5V +
3.
Samsung Electronics
RED
Fig 5-3 Center Convergence Adjustment
_ 0.2V (Using FRANCE : T101, PAL/SCAM B/G,I,D/K : L102)
5. Turn the both tabs at the same time, keeping
the angle constant, and superimpose the red
and blue horizontal line in the center of the
screen.
6. Adjust the two-tab pairs of the 6-pole magnets
to superimpose the red and blue line onto the
green. (Changing the angle affects the vertical
lines, and rotating both magnets affects the
horizontal lines.)
7. Repeat adjustments 2~6, if necessary.
8. Since the 4-pole magnets and 6-pole magnets
interact, the dot movement is complex
(Fig. 5-3).
RED/BLUE
RED/BLUE
GREEN
IF-MODULE.
Alignment and Adjustments (Electrical)
GREEN
6-Pole Magnet Movement
5-7
Advertisement
Table of Contents
