Gas powered kinetic 19 ton log splitter (32 pages)
Summary of Contents for Buffalo Tools LST30
Page 1
LST30 30 TON LOG SPLITTER INSTRUCTION MANUAL READ ALL INSTRUCTIONS AND WARNINGS BEFORE USING THIS PRODUCT. This manual provides important information on proper operation & maintenance. Every effort has been made to ensure the accuracy of this manual. These instructions are not meant to cover every possible condition and situation that may occur.
Note: If any parts are damaged or missing, do not attempt to operate this machine until the damaged or missing parts are obtained and are installed correctly Loose Parts Check all loose parts from the box with the list below. Assemble according to the instructions. LST30 30 Ton Log Splitter...
Do not operate machine with frayed, kinked, cracked, or damaged hoses, fittings, or tubing. b. Stop the engine and relieve hydraulic system pressure before changing or adjusting fittings, hoses, tubing, or other system components. c. Do not adjust the pressure settings of the pump or valve. LST30 30 Ton Log Splitter...
Page 4
Never store the machine of fuel container inside where there is an open flame, spark or pilot light as on a water heater, space heater, furnace, clothes dryer or other gas appliances. Allow machine to cool at least five (5) minutes before storing. LST30 30 Ton Log Splitter...
Page 5
6. The pressure relief valve is preset at the factory. Do not adjust the valve. 7. Never attempt to move this machine over hilly or uneven terrain without a tow vehicle or adequate help. LST30 30 Ton Log Splitter...
Page 6
EYE PROTECTION Always wear safety glasses or safety goggles when operating this machine. WARNING----MOVING WEDGE Keep hands away from wedge and moving parts. LST30 30 Ton Log Splitter...
• Keep at least several feet of clearance on all sides to allow proper ventilation. Chemicals: According to the State of California, the exhaust from this log splitter contains chemicals known to cause cancer, birth defects, or other reproductive harm. LST30 30 Ton Log Splitter...
Step 4: Use a pry bar or claw hammer to remove the plywood splinters securing the beam and tank assemblies on the crate bottom. Take out the two assemblies. Step 5: Inspect all component assemblies, parts and accessories according to the packing list. LST30 30 Ton Log Splitter Page 9...
Page 9
Unpacking tools needed: Wrench 14mm Scissors or knife Pry bar or claw hammer LST30 30 Ton Log Splitter...
Vented Dipstick Ø15*3.1 O Seal Ring Oil Drain Screw M16*15 Ø20*2.4 O Seal Ring Fitting for Oil Suction Hose Ø25*310 Oil Suction Hose Ø30 Hose Clamp Fitting on Filter for Oil Return Hose Filter Cap LST30 30 Ton Log Splitter...
Page 32
M12*45 (8.8) Hex Head Bolt Flat Washer Lock Nut Hex Head Bolt M10*35 (8.8) Flat Washer Lock Nut Cross Wedge L-shape Support M8*55 (8.8) Hex Head Bolt Lock Nut Hex Head Bolt M8*25 (8.8) Spring Washer LST30 30 Ton Log Splitter...
Page 33
Flat Washer 201410 LST30 30 Ton Log Splitter...