Table of Contents
Advertisement
Quick Links
The COM900CC COMMUNICATOR
receiver/transmitter designed to be used with the
HME Wireless Drive-Thru Audio System 900.
The Communicator is worn around the user's
collar, and a lightweight headset plugs into a
connector on the unit. Its simple, pushbutton
operation with voice cues make the COM900CC
especially user friendly.
These instructions provide detailed information for
proper use of the COM900CC. Setup information
for the audio system installer is in Appendix A.
I.
COM900CC CONTROLS AND CONNECTORS
A. Controls
HM ELECTRONICS, INC.
OPERATING INSTRUCTIONS
is a 900MHz
®
Figure 2. COM900CC control buttons
14110 Stowe Drive, Poway, CA 92064 USA ! Phone: 1-800-848-4468 Fax: (858) 552-0172
COM900CC
COMMUNICATOR
Figure 1. COM900CC COMMUNICATOR
® ®
®
HME# 400423
Rev A 11/15/02
Advertisement
Table of Contents
Subscribe to Our Youtube Channel
Summary of Contents for HM Electronics COM900CC COMMUNICATOR
- Page 1 The Communicator is worn around the user’s collar, and a lightweight headset plugs into a connector on the unit. Its simple, pushbutton operation with voice cues make the COM900CC especially user friendly. These instructions provide detailed information for proper use of the COM900CC. Setup information for the audio system installer is in Appendix A.
- Page 2 B. Connectors Plug the headset cable connector into the cable connector on the COM900CC collar unit, as shown in Figure 3. Be careful to correctly match the positions of the pins inside the connector. Figure 3. Cable connectors showing matching pin positions ®...
- Page 3 ® ® III. OPERATING THE COM900CC COMMUNICATOR To operate the Communicator, use the control buttons shown in Figure 2 as follows: ! Volume-control button C Press the up-arrow L side of the VOLUME button to increase headset volume. As the volume increases, you will hear a series of beeps in the headset earpiece, increasing in pitch as the volume increases.
- Page 4 Changes or modifications not expressly approved by HM Electronics, Inc. could void the users authority to operate this equipment.
- Page 5 APPENDIX A INSTALLER SETUP Charge batteries: Before using the COM900CC COMMUNICATOR , place the batteries in the AC900 ® Battery Charger and let them charge until the green, Ready lights go on (approximately 2 hours and 20 minutes). Reset the COM900CC: With a fully charged battery in the Communicator, reset the unit to system configuration default settings as follows.
- Page 6 Frequency selection table: Single-Lane or Dual-Lane 2 Frequencies Dual-Lane 1 Frequencies (If set for Dual-Lane Mode) Channel Receive Transmit Channel Receive Transmit Number Frequency Frequency Number Frequency Frequency 902.30 926.30 903.10 927.10 902.40 926.40 903.20 927.20 902.50 926.50 903.30 927.30 902.60 926.60 903.40...
Need help?
Do you have a question about the COM900CC COMMUNICATOR and is the answer not in the manual?
Questions and answers