1. Firmware Upgrading
1.1.
Preparation to upgrade firmware
•
Download the latest software release package.
•
Extract the files from ZIP archive and rename with "dvdrom.bin".
•
Start the CD Burning Software and create a new CD project (data disc) with the following settings:
•
File System:
•
Format:
•
Recording Mode:
Note: Long file name is necessary for the preparation of the upgrade disc.
•
Place the extracted file into the root directory of the new CD project.
•
Burn the data onto the CDRs or CD-RWs.
Notes: Burn ALL the extracted files (backend ". CUB" and Front End ". BIN") onto a blank CD-R or CD-RW disc
for firmware upgrade
1.2.
Procedures to apply the System Software Upgrade and Loader Software Upgrade
•
Open the tray and load the Upgrade CDROM with Software upgrade file.
•
The tray will close and set will display: "SW UPGD"
•
Click on the <OK> button.
•
The set will display: " UPGRADING SW"
•
After finished, open door and take out the update disc.
The whole process may take up to 5 minutes.
Note: Do not press any button or interrupt the mains supply during the upgrading process, otherwise the set
may become defective.
2. Reprogram Region Code
•
Under NO DISC state, press num key "9735" in sequence to enter customer config UI.
•
Select "REGION" option using direction key.
•
Select different region code using direction key.
•
Select "EXIT SETUP" using direction key, and press "OK"
3 - 3
Joliet
MODE 1
SINGLE SESSION (TRACK-AT-ONCE), FINALIZE CD