Switching To A Broadcast Program Of Your Choice Temporarily - JVC RX-6010RBK Instructions Manual

From the remote control:
1. Press PTY SEARCH while
listening to an FM station.
"PTY SELECT" flashes on the display.
2. Press and hold PTY +
or PTY – until the PTY
code you want appears
on the display, while
"PTY SELECT" is
flashing.
The display gives you the PTY
codes described below.
3. Press PTY SEARCH again, while
the PTY code selected in the
previous step is still on the
display.
While searching, "SEARCH" and the
selected PTY code alternate on the display.
The receiver searches 30 preset FM stations, stops when it finds
the one you have selected, and tunes in that station.
To continue searching after the first stop
Press PTY SEARCH again while the indications on the display are
flashing.
If no program is found, "NOTFOUND" appears on the display.
PTY codes
NONE
ALARM
TEST
DOCUMENT
FOLK M (MUSIC)
OLDIES
NATION M (NATIONAL MUSIC)
COUNTRY
JAZZ
LEISURE
TRAVEL
PHONE IN
RELIGION
SOCIAL (AFFAIRS)
CHILDREN
FINANCE
WEATHER
19
£
PTY SEARCH
1
1
7
PTY – DISPLAY + PTY
£
PTY SEARCH
1
1
7
PTY – DISPLAY + PTY
£
PTY SEARCH
1
1
7
PTY – DISPLAY + PTY
NEWS
AFFAIRS
INFO (INFORMATION)
SPORT
EDUCATE (EDUCATION)
DRAMA
CULTURE
SCIENCE
VARIED
POP M (MUSIC)
ROCK M (MUSIC)
EASY M (MUSIC)
LIGHT M (MUSIC)
CLASSICS
OTHER M (MUSIC)
Switching to a Broadcast Program of
Your Choice Temporarily
Another convenient RDS service is called "EON (Enhanced Other
Network)."
The EON indicator lights up while receiving an FM station with the
EON code. (The EON indicator also lights up while receiving an
AM station but the EON function will not work.)
This allows the receiver to switch temporarily to a broadcast
program of your choice (NEWS, TA, and/or INFO) from a different
station except in the following cases:
• When you are listening to non-RDS stations (all AM — MW/LW
and some FM stations).
• When the last received FM station is a non-RDS station.
• When the receiver is in standby mode.
Before you start, remember...
• The EON function is only applicable to preset stations.
On the front panel ONLY:
1. Press EON so that the last selected
program type appears on the
display.
The receiver enters EON standby mode. When the
receiver is in EON standby mode, the receiver is ready
to receive the EON data (TA/NEWS/INFO) you select.
2. Press TA/NEWS/INFO until the
program type you want appears on
the display.
• Each time you press the button, the display changes
to show the following:
TA
NEWS
TA/NEWS/INFO
TA: Traffic Announcement in your area.
NEWS: News.
INFO: Program the purpose of which is to impart advice in
the widest sense.
EON
TA/NEWS/INFO
INFO TA/NEWS
NEWS/INFO TA/INFO