Table of Contents
Advertisement
Bluetooth Setup
In the "Devices" tab select "Preferences" then "Bluetooth". This will let you name your 3Sixty.3 processors connection, enable/disable "Auto Play" and set
up a pin number used to access your unit.
NOTE
The default pin number is 0000.
NOTE
Only one BT device can connect to the 3Sixty.3 processor at a time.
Saving System Setup
The 3Sixty.3 saves the users EQ settings to the processor every time a setting is changed in the UI to prevent you from losing your work in case of
accidental disconnection with the PC. To save the file to your PC,
Adjusting Remote Output Turn On Delay
Remote Output Delay
Remote Output Delay Timing options; 1 sec, 2 sec, 4 sec, or 8 sec. This allows the user to customize
the time delay from when the 3Sixty.3 initializes (turns on) to when it turns on any external amplifiers
connected to its REM OUT (blue wire in 4 pin power harness) This extended timing ensures that the
source unit and 3Sixty.3 are on and initialized before initializing (turning on) the amplifiers, therefore
eliminating any turn on "pop" noise. To get to the delay timing select the "Devices tab", then select
preferences. The delay can then be adjusted in the drop down menu under "General Settings".
24
select the "File" in the upper left hand corner, then select "Save File As".
Device doesn't turn on.
A.
Verify connections.
B.
Verify there is 10 - 15.5 Volts present at the power B+ connection to the 3Sixty.3 unit.
C.
Contact customer service.
Device turns on with the key in the acc position but does not turn on when the vehicle starts..
A.
Verify there is 10 - 15.5 Volts present at the power B+ connection to the 3Sixty.3 unit while the starter is starting the motor.
B.
Replace battery.
C.
Contact customer service.
Power Indicator (Red LED) does not stop blinking.
A.
Turn power off to 3Sixty.3 unit, wait a moment and turn unit back on.
B.
Turn power off to 3Sixty.3 unit, press the reset button, wait a moment and turn unit back on.
C.
Contact customer service.
No audio out.
A.
Verify all connections to the 3Sixty.3 and other audio devices in your system.
B.
Verify that all audio devices connected to the 3Sixty.3 unit have power on.
C.
The processor is muting the outputs because you are configuring the input.
D.
The outputs are muted in the EQ controls.
Distorted audio at high volumes.
A.
The source unit has exceeded the maximum volume level found during configuration.
B.
The EQ in the source unit has been adjusted after the processor was setup.
System does not respond to 3Sixty.3 remote controller.
A.
Check cable connection between 3Sixty.3 and remote.
B.
Check the feature settings of the remote in the PC interface, since it may control the sub or master volume, you may need to choose the best
setting for your system.
C.
Voltage has dropped below 9VDC.
Cannot connect to Bluetooth.
A.
Ensure all other previously connected BT devices within range are disconnected.
B.
Check BT dongle connection.
C.
BT dongle reception is poor, keep the dongle away from any ferrous (metallic) material.
25
Hide quick links:
Advertisement
Table of Contents
Troubleshooting
