Advertisement
NOTE:
Keep the transmitter and receiver 40cm apart when operating
Do not operate the radio system when the battery power is low
Binding the transmitter and receiver
1. Turn on the receiver power. Press the Bind switch.
The receiver's LED should start flashing.
2. Turn on the transmitter.
3. When the LED on the receiver becomes solid,
the binding process is completed.
4: Press the SEL button to conclude the settings. The newly entered values are saved automatically.
Forward
Neutral
Speed up
1. Pull trigger backward to accelerate.
2. Push the trigger forward to
slow down or brake.
Fail Safe function setting
1. Set the TH, ST switches to the normal position.
2. Turn on the transmitter and receiver.
3. Press the F/S SET button, the LED on the receiver should start flashing rapidly.
4. Put the throttle trigger at the brake position, press the F/S SET button, the LED should become solid.
5. For electric model, put the throttle trigger at the stop position when you are making the setting.
Trouble shooting
If your system fails to operate or you experience a short range problem or else, check the table below for possible
causes. If after you have followed the listed suggestions, the problem has not been corrected, return the system to your
re-seller for inspection and/or repair.
1. TRANSMITTER
Battery: Dead battery- Change the battery or charge the battery.
Battery inserted incorrectly- reload the battery according the polarity markings.
Faulty contact: Check if the contacts are bent and not making good contact.
Dirty contacts - clean the contacts and check for corrosion.
2. RECEIVER
Battery: Dead battery- Replace the battery or recharge. Wrong polarity- check connections.
Antenna: Near other wiring- move away from wiring.
If antenna was cut, please request repair.
If antenna is bundled or coiled- keep antenna as straight as possible.
3. CONNECTOR CONNECTIONS
Wiring incorrect- insert all connectors firmly.
4. LINKAGE
Binding or loose- adjust the linkage in the model.
5. MOTOR
Noise problem- install capacitors on motor.
www.dragon-rc.com - Accessories for radio controlled cars - Dragon-RC is a registered brandname.
Brake
Speed down
Throttle Trim:
Trim the throttle servo slightly when
the trigger is at the neutral position.
Turn the steering wheel to the left or
right to let the car turn left or right.
Steering Trim:
If the front wheels don't allign straight,
use the steering trim to adjust.
Advertisement
