Volvo 2012 C30 Owner's Manual page 88

02 Instruments and controls
®
HomeLink Wireless Control System*
Erasing HomeLink Buttons
To erase programming from the three Home-
02
Link buttons (individual buttons cannot be
erased but can be "reprogrammed" as outlined
below), follow the step noted:
1. Press and hold the two outer HomeLink
buttons until the indicator light begins to
flash-after 10 seconds.
2. Release both buttons. Do not hold for
longer that 20 seconds.
HomeLink is now in the train (or learning) mode
and can be programmed at any time beginning
with "Programming" - step 1.
Reprogramming a Single HomeLink
Button
To program a device to HomeLink using a
HomeLink button previously trained, follow
these steps:
1. Press and hold the desired HomeLink but-
ton. DO NOT release the button.
2. The indicator light will begin to flash after
20 seconds. Without releasing the Home-
Link button, proceed with "Programming"
- step 1.
2 The term "IC:" before the certification/registration number only signifies that Industry Canada technical specifications were met.
*
88
Option/accessory, for more information, see Introduction.
For questions or comments, contact HomeLink
at: www.homelink.com or 1–800–355–3515.
This device complies with FCC rules part 15
and Industry Canada (IC) RSS-210. Operation
is subject to the following two conditions: (1)
This device may not cause harmful interfer-
ence, and (2) This device must accept any
interference that may be received including
interference that may cause undesired opera-
tion.
NOTE
The transmitter has been tested and com-
plies with FCC and IC rules. Changes or
modifications not expressly approved by
the party responsible for compliance could
void the user's authority to operate the
2
device.
I n f o r m a t i o n P r o v i d e d b y :