Advertisement
4.8 VOLT CORDLESS SCREWDRIVER
OPERATING INSTRUCTIONS
The safety instructions should be read carefully before operating the screwdriver.
Caution
Charging time should not exceed 5 hours.
Specifications
Screwdriver:speed:150rpm;
chuck:1/4"=6.35mm (male);
forward/reverse switch for unscrewing/screwing;
rechargeable battery:4.8V;
acoustic pressure level:Lpa<70d
emitted vibration:acceleration<2.5m/s
Charger:input:120V AC 60Hz
protection against electric shock, class ll;
protection against moisture (IP 20);
output:6v dc,30 0mA
Safety instructions
The following recommendations should be strictly complied with before operating the
screwdriver in order to avoid damage to the equipment and hazard to the user.
1.
Wear individual protection equipment if necessary (gloves, shoes, eye protectors,
breathing filters, etc.). Do not wear jewelery or close-fitting clothing, protect long
hair.
2.
Disconnect the charger when not in use or when you replace a tool bit.
3.
Work in a clean and tidy room with sufficient lighting.
4.
Place and store the screwdriver in a dry place, far from heat or dangerous vapors
(best temp. is between 10 and 15°C). Do not operate the screwdriver close to
explosive substances or inflammable material.
5.
Use screwdriver adapted to the task to be performed. This do-it-yourself
screwdriver should be used as such and not be considered as heavy-duty equipment.
6.
Do not work close to people, particularly children if work is hazardous. Keep
screwdriver away from children during and after work.
7.
When drilling metal sheets, use a vice and a block of wood placed under the sheet.
8.
Make sure you do not use the screwdriver on live parts to avoid electric shock.
Make sure you locate any electric wire or cable inside the wall before using the tool.
9. Do not try to open or disassemble the screwdriver or the charger.
10. If the charger is damaged (case,wires or plug), replace it immediately.
11. This screwdriver does not require special maintenance. The same applies to the
electrical parts of the tool.
12. Plastic parts should be cleaned only after disconnecting the charger. Use a wet cloth
(A)
B
and soft soap. Do not immerse the screwdrover or the charger in any liquid. The use
of solvent, alcohol, petrol, etc. is prohibited.
Operation
CAUTION: Safety Instructions should be read carefully before operating the
screwdriver.
Power supply:
Plug the supply connection into the screwdriver's battery pack. The screwdriver is
fully charged after 5 hours.
Screwing/unscrewing:
The screwdriver is equipped with a forward / reverse switch(lever) to change chuck
sense of rotation.
1.clock wise,pusch the button
2.anti-clock wise,pusch the button
To stop rotation,slacken the switch.
Maintenance
This screwdriver does not require special maintenance.
plug
adaptor
Advertisement
