Table of Contents
Advertisement
The spark plugs in your car should
be replaced according to the time
and distance recommendations in
the maintenance schedule.
Replacement
HOLDING CLIP
1. Loosen the two holding clips by
turning the heads one-quarter turn
counterclockwise with a flat-tipped
screwdriver. Remove the cover on
the front cylinder bank by pulling
it straight up.
Spark Plugs (6-cylinder Models)
2. Clean up any dirt and oil that have
collected around the ignition coils.
3. Disconnect the wire connector
from the ignition coil by pushing
on the lock tab and pulling on the
connector. Pull on the plastic
connector, not the wires.
CONTINUED
Advertisement
Table of Contents
