Advertisement
Quick Links
Warning: Do not apply pressure to the iPod screen
when removing it from the Cradle. This can damage
youriPod.
USAGEill'
Tips for Best Performance
How 10 Remove thelPod from the
CncIe
The correct way to remove the iPod from the GPS
~~~d~~~~
:hegGapl
~:Jreo:~~~:~~th~l~t~~~.h;;r·
gently on the iPod to remove it from the Cradle.
Holder Wiring
~~ =~~wer
adaplor to connect Holder
to vehicle's power source to power GPS and charge
iPod.
Audio Out
Use Audio Out port
10
connect Holder to vehicle
stereo system with 3.5 mm mini stereo audio cable.
Removing iPod
To remove iPod and Cradle from Holder. pull back
on tab at top of Holder. and iPod and Cradle will
slide out easily.
Note, The
GPS will operate even when iPod and
Cradle are not positioned in Holder.
INSTALLATION _
Tips for Best Performance
Hold tho GPS Cradle Upright
The GPS antenna is near the top of the Cradle and
faces out the back. Try to aV(lid covering Ihe antenna
with your hand or laying it down on its back for
long periods of time. The CradLe performs best when
it has an unobstructed view of the sky.
Tem~,ilytum
orrWlR
When turning on the GPS CradLe. you can often
shorten the amount of time reqUired to determine
your position by temporariLy turning off WiFi on the
iPod. Once the iPod is showing your location (in any
appl. you can turn WiFi back on.
USB Porl
Use included mini USB
10
USB cable to connect unit
to computer for charging I syncing iPod.
H..dphone Jack
To listen wilh headphones. plug headphones inlo
headphone jack at base of unit.
Volume
Volume controls on Cradle allow easy volume
adjustment.
Power
SwitdI
Move
Power
switch
to GPS to power GPS
fundion. When not
using GPS, move Power
switch
10
Battery to
charge iPodtouch orto
Off to save battery.
Battery
Indicator
Press Battery Indicllor
bunoo, and Ihe four LED
lights above will illuminale to
indicate current charge.
Cradle Controls
Volume~
US8Porl~
HNdphOM Jack
VolulM Up
4
_
INSTALLATION
Installation
INSTALLATION _
• Slide iPod touch and Cradle into Holderas
illustrated in Figure3 (above)
• To adjust viewing angle. lighten octagonal nul to
hold tke Holder in place. then rotate to desired
viewing angle.
~i~~=toCradleasiUustrated
in
Figure
2
(below). If using first generation iPod
touch. remove rubber spacer from Cradle before
inserting iPod.
Installing
c.r Windshield Mount
• For best hold. first clean the windshield glass in
desired mounting tocation.
• Raise Ieveron Mount. attach to Mount 10 window
in desired Location and depress lever to secure.
Mounting Location
• Attach Mount in location Ihat is easity within reach
from driver's seat.
• Ensure Ihat chosen location will not obstruct
visibility. mirrors. airbags or any vehicle controls.
Not..
certain states regulate mounting locations
for safety reasons. Be sure to check and adhere to
local regulations when attaching Mount.
Atlachl"ll_
• Align four slots on
back of Holder with
Figure 1
four clips on front of
Mount as illustrated
in Figure 1 (at
rightl.5Udeunlil
Holder clicks
into place.
Preparation
The Portable GPS
&
Battery Cradle provides both GPS
Location data and backup ballery power to any 1st.
2nd or 3rd generation Pod
louch~.
Use the included
Car Windshield Mount to secure the iPod and GPS
CradLe in a vehicle for easy access while on the road.
Note: The GPS Cradle is only designed to
fit
an ,Pod
touch. Inserting any olher device. such as
iPhon~
can cause damage to
both
the unit and the device.
_
INSTALLATION
INSTALLATIONI
OWNER'S MANUAL
Portable GPS & Battery Cradle
for iPod touch
Advertisement
