JVC HD-56GC87 User Manual page 19

Connecting to a Digital TV Receiver
By connecting a Digital TV Receiver, high definition pictures can be displayed on your TV in
their digital form.
DTV device
Digital Out
1) Connect the HDMI to DVI Cable from the DIGITAL OUT on the back of your DTV decoder, to
the DIGITAL-IN on the back of your television.
2) Connect a red cable from the DTV decoder RIGHT AUDIO OUT, to the RIGHT AUDIO INPUT
"HDMI 1" on the back of your television.
3) Connect a white cable from the DTV decoder LEFT AUDIO OUT, to the LEFT AUDIO INPUT
"HDMI 1" on the back of your television.
• The digital-in terminal is not compatible with the picture signal of a personal computer.
• Use a HDMI to DVI cable (commercially available) in order to digitally connect the television
with a DTV decoder.
Notes:
• If 480p signals (640x480 or 720x480) are displayed on the screen, the horizontal balance
may be slightly shifted. Access the "DIGITAL-IN" in the initial setup menu to adjust it. (Refer
to page 50.)
• When you do the above connection, set "DIGITAL-IN1 AUDIO" in the Initial Setup menu to
ANALOG. See "DIGITAL-IN1 AUDIO", page 48.
• The Analog Audio input can only be used with the HDMI 1 input.
• When setting the "DIGITAL AUDIO – ANALOG / DIGITAL" menu setting on the TV, please note
that this setting only effects the HDMI 1 jack and that if you use a DVI to HDMI adapter this
connection must be made to the HDMI 1 along with analog audio cables.
Audio Out
L R
HDMI to DVI Cable
After the connections have been made,
tighten the screw to secure the cables.
Quick Setup
TV Rear Panel
R - AUDIO - L
HDMI 1
SERVICE
ONLY
1
DIGITAL-IN
2
19