Advertisement
2. DISPLAY OF
STANDBY (1)
FLASH COUNT
Lamp ON 300ms
Lamp OFF 3 sec
Lamp OFF 300ms
3. STOPPING THE
STANDBY (1)
Turn off the power switch on the TV main unit or unplug the power cord from the outlet to stop the STANDBY (1)
indicator from flashing.
4. SELF-DIAGNOSTIC SCREEN DISPLAY
For errors with symptoms such as "power sometimes shuts off" or "screen sometimes goes off" that cannot be confirmed,
it is possible to bring up past occurrences of failure on the screen for confirmation.
[To Bring Up Screen Test]
In standby mode, press buttons on the remote commander sequentially in rapid succession as shown below:
/ Channel 5 / Volume
Display
The following screen will be displayed indicating the error count.
ERROR MENU
2 :
0
3 :
N/A
4 :
0
5 :
1
8 :
0
101 :
N/A
INDICATOR
INDICATOR FLASH
/ Power
˘
Note that this differs from entering the service mode (volume [+]).
Numeral "0" means that no fault was detected.
Numeral "1" means the number of a fault occurrence (1 ~ 255).
Diagnostic Item
+B overcurrent
V-Protect
IK (AKB)
HV Protect
* One flash count is not used for self-diagnosis.
STANDBY u indicator
/ TV
– 5 –
KV-21CL5K
RM-W100
Flash Count*
2 times
4 times
5 times
8 times
Advertisement
Chapters
