Water Connection; Start Of Dishwasher - Bompani BOLT945 Instruction Manual

Table of Contents

Advertisement

The safety supply hose consists of the double walls. The hose's system guarantees its intervention by blocking the flow of water
in case of the supply hose breaking and when the air space between the supply hose itself and the outer corrugated hose is full
of water.
A hose that attaches to a sink spray can burst if it is installed on the same water line as the dishwasher. If your sink has one, it is
recommended thet the hose be disconnected and the hole plugged.
1
Turn off the water.
2
Release the water pressure by depressing the pressure release button. This relieves water pressure and protects you, and
the room, from severe splashing.
3
Unscrew The safety supply hose from the faucet..
Connect the cold water supply hose to a threaded 3/4(inch) connector and make sure that it is fastened tightly in place.
If the water pipes are new or have not been used for an extended period of time, let the water run to make sure that the
water is clear and free of impurities. If this precaution is not taken, there is a risk that the water inlet can get blocked and
damage the appliance.
The following things should be checked before starting the dishwasher.
1
The dishwasher is level and fixed properly
2
The inlet valve is open
3
There is a leakage at the connections of the conducts
4
The wires are tightly connected
5
The power is switched on
6
The inlet and drain hoses are knotted
7
All packing materials and printings should be taken out from the dishwasher
The appliance must be connected to the water mains using new hose-sets.
The old hose-sets should not be reused.
Water pressure must be between 0,04 MPa and 1 MPa. If the pressure is below the minimum
consult our Service Department for advice.
1
Pull The safety supply hoses completely out from storage compartment located at rear of dishwasher.
2
Tighter the screws of the safety supply hose to the faucet with thread 3/4inch.
3
Turn water fully on before starting the dishwasher.
After installation, please make sure to keep this manual.
The content of this manual is very helpful to the users.

Hide quick links:

Advertisement

Table of Contents
loading

This manual is also suitable for:

Bolt945/e

Table of Contents