Alcatel OnTouch Pop S3 Manual page 11

Installing or removing the battery
• To install, insert and click the battery into place, then close the phone
cover.
• To remove the battery, first power the phone off. Then unclip the cover
and remove the battery.
Charging the battery
Connect the battery charger to your phone and mains socket respectively,
the LED indicator will light while charging.
19
• Make sure the battery is correctly inserted before connecting the
charger.
• When using your telephone for the first time, charge the battery fully
(approximately 3 hours).
You are advised to fully charge the battery (
indicated by a percentage displayed on screen while the phone is powered
off. The percentage increases as the phone is charged.
To reduce power consumption and energy waste when the battery
is fully charged, disconnect your charger from the plug; switch off
Wi-Fi, GPS, Bluetooth or background-running applications when
not in use; reduce the backlight time, etc.
1�2�2 Power on your phone
Hold down the Power key until the phone powers on, unlock your phone
(Slide, PIN, Password, Pattern or Face unlock) if necessary and confirm. The
Home screen is displayed.
If you do not know your PIN code or if you have forgotten it, contact your
network operator. Do not leave your PIN code with your phone. Store this
information in a safe place when not in use.
Set up your phone for the first time
The first time you power on the phone, you should set the following
options:
• Select the phone's language, then touch
• Select the input method, then touch
• Set your Mobile Data Connection, then touch
• Set your Date & time, then touch
). Charging status is
.
.
.
.
20