Cooper Menvier 524 User Manual

524 Remote Keypad - User Guide

Introduction

The 524 Remote Keypad is designed to work with the 500r+ or 690r wirefree
alarm system control units. The keypad allows you to set and unset the alarm
system, and if necessary activate a PA (panic alarm).
You can program the keypad to use an access code from three to eight digits
long. This access code can be different from the access code you use at the
alarm system control unit.
Figure 1 below shows the main features of the keypad.
Low Battery LED
(yellow)
Unset key

Changing the User Code

You can store a single access code on the keypad. The access code can
have between three and eight digits, and does not have to be the same as
the access code for the alarm system control unit. Do not use "0" as the first
digit of the keypad access code. To store your access code:
1. Press ..
The red LED glows.
2. Key in the current access code. (The default access code is "1234".)
3. Press ..
4. Key in the new access code. (Minimum three digits, eight digits maxi-
mum.)
1 2 3
4 5 6
7 8 9
0
Part Set key
Figure 1.
496573 Issue 1
Activity LED
(red)
Set key
1