Lectronix T8510 User Operating Instructions Manual page 21

Tire Details
When viewing the main Tire Pressure screen, details for each tire may be viewed by touching the icon for
the tire of interest. The Tire Details screen shows the tire pressure, deviation from the target pressure
and the temperature of the tire. Three options are available on this screen:
Tire Diagnostics
Touch this button to show information about the sensor on the tire. This information can be used
to troubleshoot a sensor that is experiencing a problem.
Unassign Sensor
If a sensor needs to be removed from the vehicle, touch the Unassign Sensor button before
removing the sensor. The icon on the selected tire will show an hourglass then a slashed circle
which indicates the sensor has been deleted from the VIS.
Learn Sensor
When there is no sensor assigned to a displayed wheel, the Learn button is displayed. To add a
sensor at the current wheel position, touch the Learn button then, using the SmartWave
handheld unit, go to the wheel on the vehicle with the new sensor and cause the sensor to
broadcast its' presence (follow instructions in the SmartWave
Configuration
When viewing the main Tire Pressure screen, press the menu button
the tire pressure monitoring system. The options available are:
Notifications
Notifications Enabled – enable or disable notifications
Notifications Sound – allows you to select your notification sound
Auto-Launch Applications – determine whether you want the alerts to launch automatically when
a fault occurs
Wake System – determine if you want the system to wake up upon alert
Tractor Type sets the tire configuration for the tractor which can be 6x4 Duals, 6x4 Singles or 4x2
Duals
Adjust Target Pressures
Setting Target Pressures: a target tire pressure is set for each axle based on the proper
inflation for those tires. The VIS and the SmartWave
determine over/under-inflation conditions. To set target pressures, from the main Tire Pressures
screen, touch the Adjust Target Pressures button. Each axle is now shown with the current
target pressure for each. To adjust the target pressure, touch the Up or Down Arrow icons
above and below each axle. The new target pressures will be shown. When finished, touch the
Accept button at the bottom of the screen.
Display Options – configures the data to be shown on the main tire's graphic
Tire Pressure
Tire Temperature
Deviation from Target
Installing or Removing Tire Pressure Sensors
In the event that it becomes necessary to remove, replace or install a tire pressure sensor, use the
unassign and learn buttons noted above.


system will use this target pressure to
16

, then touch setting to configure