JVC HR-XVC37U Instructions Manual page 75

8 PICTURE CONTROL
NORM
EDIT
SOFT
SHARP
8 3DNR
ON
ON (PLAY)
OFF
8 SUPERIMPOSE
ON
OFF
This feature helps you to adjust the playback picture quality according to your
preference. Normally select "NORM".
NORM: Picture quality is adjusted automatically.
EDIT: Minimizes picture degradation during editing (recording and
playback).
SOFT: Reduces image coarseness when viewing overplayed tapes
containing a lot of noise.
SHARP Clearer, sharper-edged picture when viewing images with lots of flat,
same-colored surfaces such as cartoons.
NOTES:
When you select "EDIT", "SOFT" or "SHARP", the selected mode will not change until you
select another mode.
When you select "EDIT" to dub tapes, be sure to select "NORM" after you finish dubbing
the tapes.
The 3DNR picture system applies the noise reduction to reduce small noise,
enabling clear picture with less roughness.
ON: The 3DNR picture system is activated to reduce noise appearing on
playback picture of a VHS cassette, on-air picture of the tuner, and
picture from the external source connected to the unit (through the
AUDIO/VIDEO input (F-1) connector). However, this feature does
not affect recording signals. This mode is preferable when small noise
and roughness are obvious on on-air picture of the channel to be
recorded.
ON (PLAY): The 3DNR picture system is activated only for playback picture of
a VHS cassette. On-air picture of the channel to be recorded and
picture from the external source connected to the unit (through the
AUDIO/VIDEO input (F-1) connector) will not be affected.
OFF: The 3DNR picture system is not activated for playback picture of a
VHS cassette.
NOTES:
Signals to be recorded onto a tape are not affected even when "3DNR" is set to "ON" or
"ON (PLAY)".
Normally it is recommended to keep "3DNR" set to "ON (PLAY)".
Depending on the type of tape being used, picture quality may be better with "3DNR" set
to "OFF".
If you use the VCR as the source player for editing, be sure to set "3DNR" to "OFF" before
starting.
When this function is set to "ON", various operational indicators appear on the TV
screen. Messages appear in the selected language. (
NOTES:
When you use this unit as the source player for editing, be sure to set "SUPERIMPOSE" to
"OFF" before starting.
During playback, the operation mode indicators may be disturbed depending on the type of
tape being used.
* The default setting is bold in the table below.
pg. 20)
75
EN