Safety Alert Symbol; Signal Words; Safety Decals; Canadian Csa Requirements - Empyre Elite XT 100 Installation And Operation Instructions Manual

SAFETY

Safety Alert Symbol

The Safety Alert Symbol identifies
important safety messages in the manual
and on the furnace. When this symbol
is present, be alert to the possibility of
injury or death. Follow all instructions in
the safety message given. This symbol means attention,
be alert, and your safety is involved.
Why is SAFETY important to you? Three very important
reasons:
1. Accidents disable and can be fatal.
2. Accidents cost.
3. Accidents can be avoided.

Signal Words

Note the use of the signal words: DANGER, WARNING
and CAUTION with the safety messages.
The appropriate signal word has been selected using
the following guidelines:
DANGER
DANGER: Indicates an imminently hazardous situation
that, if not avoided, WILL result in death or serious
injury if proper precautions are not taken.
WARNING
WARNING: Indicates a potentially hazardous situation
that, if not avoided, COULD result in death or serious
injury if proper precautions are not taken.
CAUTION
CAUTION: Indicates a potentially hazardous situation
that, if not avoided, MAY result in minor or moderate
injury if proper practices are not taken, or serves as a
reminder to follow appropriate safety practices.
6

Safety Decals

Please read and follow directions to ensure safe
practices when using the Empyre Elite XT furnace.
1) DANGER/WARNING/CAUTION
Safety Instructions: Located on the left side near
the controls.
2) FURNACE SERIAL DECAL – Located on the left side
near the controls.
3) ELECTRICAL/INSTALLATION:
Located near the back of the side panel.
4) CAUTION: Lid area may be very hot. Switch blower
off before opening. Located right of centre back
flue clean out cover.
5) WARNING: ELECTROCUTION HAZARD. Always
secure door with latch. Tighten with wrench.
Located above latch of rear access door.
6. ELECTRICAL WIRING DIAGRAM - Located inside
rear access door.
7) SPECIFICATIONS – Located near the back of the
side panel of the furnace.

Canadian CSA Requirements

Installation of the Empyre Elite XT as an add-on unit
in the Canadian provinces and territories must comply
with requirements of CAN/CSA-B365, and changes
to the installation must comply with the following CSA
requirements:
CSA B139 - for oil-fired
CSA C22.1 - for electric
CAN/CGA-B149.1 or CAN/CGA-B149.2 - for gas-fired
EMPYRE ELITE XT INSTALLATION AND OPERATION MANUAL