Toyota 2001 HIGHLANDER Owner's Manual page 130

If "WAIT" appears on the display, it indi-
cates that the inside of the player unit
may be too hot due to the very high ambi-
ent temperature. Remove the disc or mag-
azine from the player and allow the player
to cool down.
If "Err 1" appears on the display, it
indicates the disc is dirty, damaged, or it
was inserted up–side down. Clean the
disc or insert it correctly.
If "Err 2" appears on the display, it
indicates no disc is loaded inside the
magazine. Insert a disc.
If "Err 3" or "Err 4" appears on the
display, it indicates there is a trouble in-
side the system. Eject the disc or maga-
zine. Set the disc or magazine again.
If "OPEn" appears on the display, it
indicates the compact disc auto changer
lid is open. Close the compact disc auto
changer lid.
If the malfunction is not rectified, take
your vehicle to your Toyota dealer.
130
'01 HIGHLANDER_U (L/O 0106)
DISC "
Compact disc auto changer only—
By using this button, you can select a
disc you wish to listen to.
Push either side of the button until the
number of the disc you want to listen to
appears on the display.
CONTROL / MODE (Audio control and
mode adjustment)
Manual tone adjustment function—
This knob is used to adjust the tone
manually.
For low–pitch tone adjustment,
"CONTROL / MODE" repeatedly
"BAS" appears on the display. Then turn
the knob to suit your preference.
The display will show the range from
"BAS –5" to "BAS 5".
Vehicles with 8 speakers only—for middle–
pitch tone adjustment, push "CONTROL /
MODE" repeatedly until "MId" appears on
the display. Then turn the knob to suit
your preference.
The display will show the range from "MId
–5" to "MId 5".
2001 MY HIGHLANDER_U (OM48432U)
For high–pitch tone adjustment,
"CONTROL / MODE"
"TRE" appears on the display. Then turn
the knob to suit your preference.
The display will show the range from
"TRE –5" to "TRE 5".
Sound balance adjustment function—
This knob is also used to adjust the
sound balance between the front and rear,
and the right and left speakers.
For front/rear adjustment, push "CONTROL
/ MODE" repeatedly until "FAd" appears
on the display. Then turn the knob to
push adjust the front/rear balance.
until
The display will show the range from
"FAd–F7" to "FAd–R7".
For left/right adjustment, push "CONTROL
/ MODE" repeatedly until "BAL" appears
on the display. Then turn the knob to
adjust the left/right balance.
The display will show the range from
"BAL–L7" to "BAL–R7".
push
repeatedly until