Advanced (Sub-Menu 2/4) - Asus mes-vm User Manual

IV. BIOS SETUP

Advanced (sub-menu 2/4)

I/O Device Configuration
Onboard FDC Controller: [Enabled]
When Enabled, this field allows you to connect your floppy disk drives to the onboard
floppy disk drive connector instead of a separate controller card. If you want to use a
different controller card to connect the floppy disk drives, set this field to Disabled. The
configuration options are: [Disabled] [Enabled].
Onboard Serial Port 1: [3F8H/IRQ4]
This allows you to set the address for the onboard serial connector. Serial Port 1 and
Serial Port 2 must have different addresses. The configuration options are: [3F8H/
IRQ4] [2F8H/IRQ3] [3E8H/IRQ4] [2E8H/IRQ10] and [Disabled].
Onboard Serial Port 2: [2F8H/IRQ3]
This allows you to set the address for the onboard serial connector. Serial Port 1 and
Serial Port 2 must have different addresses. The configuration options are: [3F8H/
IRQ4] [2F8H/IRQ3] [3E8H/IRQ4] [2E8H/IRQ10] and [Disabled].
UART2 Use Infrared: [Disabled]
When enabled, this field activates the onboard infrared feature and sets the second
serial UART to support the infrared module connector on the motherboard. If your
system already has a second serial port connected to the onboard COM2 connector, it
will no longer work if you enable the infrared feature. By default, this field is set to
Disabled, which leaves the second serial port UART to support the COM2 serial port
connector. See IrDA-compliant infrared module connector under in HARDWARE
SETUP. The configuration options are: [Disable] [Enabled].
ASUS MES-VM User's Manual 45