5. Mount anchors (not included) to where the holes were marked at in the previous step. 6. Mount the repeater using four (4) screws (not included). Page 2 Valcom 5614 Hollins Road Roanoke, VA 24019 Phone: (540) 563-2000 Fax: (540) 362-9800 www.valcom.com...
(Rev 1.04) Jumper Settings for the V-WMCR as a Repeater or Transmitter Represents jumpers set as a repeater Represents jumpers set as a transmitter Page 4 Valcom 5614 Hollins Road Roanoke, VA 24019 Phone: (540) 563-2000 Fax: (540) 362-9800 www.valcom.com...
LED Indicators for Valcom Digital Correction to the V-WMCR When Used as a Transmitter LED Indicators If the V-WMCR is receiving communication while in transmitter mode, the LEDs in the figure shown above will flicker consistently with one another. Page 5...
Valcom Digital Correction to the V-WMCR When Used as a Transmitter V-GPS V-WMCR * NOTE: When connecting the V-WMCR, the polarity must be correct to function correctly. Page 6 Valcom 5614 Hollins Road Roanoke, VA 24019 Phone: (540) 563-2000 Fax: (540) 362-9800 www.valcom.com...
Page 7
Valcom Digital Correction to the V-WMCR When Used as a Transmitter V-WMC 20 19 V-WMCR * NOTE: When connecting the V-WMCR, the polarity must be correct to function correctly. Page 7 Valcom 5614 Hollins Road Roanoke, VA 24019 Phone: (540) 563-2000 Fax: (540) 362-9800 www.valcom.com...
How do you make the Repeater a Transmitter? With the repeater powered down, switch both jumpers from repeater to transmitter. Then connect the Valcom digital output of any Valcom Master Clock to the Valcom Digital input on the repeater, 4 & 5.
FCC Rules Note: For precautionary measures, FCC recommends a distance of 10cm from the clock to con- stant human physical exposure. Page 9 Valcom 5614 Hollins Road Roanoke, VA 24019 Phone: (540) 563-2000 Fax: (540) 362-9800 www.valcom.com...