Table of Contents
Advertisement
Assembly Instructions
1. Attach wall mount to a flat surface using the screws provided.
2. Insert the round end of the brush roll against the side-intake. Push the end
card of the opposite end of the brush roll into the channel until the end
card "snaps" into place.
3. Attach handle to the end of strut with the telescopic wand adjustment.
Pressing down the locking tab, slide shorter strut over longer strut until
locking tab catches. Insert assembled handle into base until it locks in place.
4. Loosen the telescopic wand adjustment to lengthen or shorten the handle
to the desired length and then tighten telescopic wand adjustment. Insert
battery into battery compartment until it "snaps" in place. Connect the power
adapter and allow the unit to charge for 14 hours.
The LED charging display will light red when charging. If the LED does not
light when charging, check to make sure the unit is in the OFF position.
When the LED on the power adapter changes to green, the battery is fully
charged.
NOTE: The unit will not charge if left in the ON position.
It is recommended that you remove the power adapter from the unit once
the unit has completely charged
Model 5328 Owners Guide
4
Advertisement
Table of Contents
