LITTLE BEAVER How-To Series User Manual

TROUBLE CAUSE
Motor will not 1) Toggle kill switch on handle
start is off.
2) Engine stop switch is in "OFF
or "O" position.
3) Torque tube is not connected
at the engine end.
4) Fuel level is too low in gas
tank.
5) On oil guard equipped
engine, oil level is too low.
6) Spark plug is fouled.
Cannot connect 1) Foreign matter clogging
or disconnect adaptor.
auger. 2) Spring and button in top of
auger is bent or broken.
3) Adaptor is bent.
Auger turns too 1) Too much down pressure or
binding on side of hole.
slowly and will
Hold back if necessary to
not dig.
allow auger to turn at full
speed.
Auger turns but 1) Foreign matter collected
will not dig. around point.
2) Point or blade is dull.
3) Wrong type blade for soil
conditions. Contact dealer
or factory for Little Beaver
carbide blades.
Auger with ex- 1) Auger or extensions bent or
tension will not running out of line.
dig. 2) Number of extensions
exceeds machine capacity.
1) It is normal for the
Transmission
transmission to run very
overheats.
warm to the touch. If you feel
it is too hot, consult your
dealer or factory.
Auger turns when 1) Do not use. Contact your
engine idles. dealer or factory.
Problems not 1) Contact your dealer or
listed in table. factory.
For Further Inquires Call: 1-800-227-7515
SAFETY PRECAUTIONS
DANGER: Failure to observe
safety instructions and reasonable
safety practices can cause Property
Damage, Serious Bodily Injury and/or
Death. BE CAREFUL!! WATCH OUT FOR
BYSTANDERS!!
DANGER: NEVER run engine
inside building or enclosed area.
DANGER: NEVER drill
where there is a possibility
underground power cables or other
hazards.
WARNING: Augers are not to be used as anchoring
devices.
CAUTION:
•
READ and understand your operator's manual and
the operator's manual for the engine.
•
NEVER Operate drill without correctly installing
torque tube.
•
NEVER Remove auger from hole while auger is
turning.
•
NEVER Operate auger at less than full throttle.
•
NEVER Operate drill with damaged auger or other
damaged or missing parts.
•
KEEP Hands, Feet and Clothing away from moving
parts while engine is running.
•
KEEP All safety shields and devices in place.
•
MAKE Certain everyone is clear before operating
the machine.
•
KEEP leg pad against leg while drilling to maintain
safe control.
•
WEAR SAFETY GLASSES.
•
KEEP Bystanders away from work area.
•
SHUT OFF Engine to adjust, service or clean the
machine .
Little Beaver How-To Series
Basic Operating Instructions for
the Mechanical Earth Drill
holes
of
For over 40 years, the versatile Little Beaver
mechanical earth drill has been the #1
choice of professionals who require a one-
man auger that is safe and simple to oper-
ate. Thanks to our unique Torque Tube,
we've eliminated the kickback found in
other drills and made one-man post hole
drilling safe and productive. Follow the in-
structions in this guide to ensure proper op-
eration.
LITTLE BEAVER
EARTH DRILLS & AUGERS
P.O. Box 840
Livingston, TX 77351
936-327-3121 ph * 936-327-4025 fax
1-800-227-7515