Summary of Contents for Source Elements VO2GO Lite
- Page 1 “VO2GO Lite” Portable Voice Over Kit User Guide (no printer) ElDorado Recording Services Copyright Dec. 2009...
- Page 2 Establishing an Internet Connection **IMPORTANT! DO THIS IMMEDIATELY UPON ARRIVAL WHEN TRAVELING TO NEW PLACES. YOU DONʼT WANT TO WAIT UNTIL THE LAST MINUTE ONLY TO FIND OUT THE SERVICE IS INADEQUATE AT YOUR HOTEL OR HOUSE. 1. This depends on your accommodations. You may have WiFi or you may have a hard-line Ethernet cable.
- Page 3 Quickstart Assembly Audio cables are numbered to help guide you 1. Remove computer (should have power supply) 2. Remove the MBox and MM-1 (mic pre-amp) 3. Stack the MM-1 on top of the MBox. Connect the cables between the two units as labeled.
- Page 4 Starting Source-Connect Session with “Source Elements Desktop” 1. Set mic pre-amp (MM-1) gain control to -28 as a starting point 2. Plug headphones into the jack on the mic pre-amp (MM-1) 3. Headphone volume adjusted with “phones” knob on the pre-amp (MM-1) 4.
- Page 5 ALTERNATIVE: Starting Source-Connect Session with Pro Tools 1. Launch ProTools using Source Connect template on the desktop 2. Click “Record Arm” button for “Mic” track in ProTools (“R” button) 3. Set mic pre-amp (MM-1) gain control to -28 as a starting point 4.
- Page 6 APPENDIX: Tutorial: Tips on connecting from a remote location Firewall Tips: Firewalls generally don't like to let incoming data get through. Firewalls are built specifically to deny any incoming traffic that isn't specifically requested, and Source- Connect data may appear to the firewall as undesirable traffic. There are a couple of ways around this, however: # Ask the Hotel manager to put you on the 'DMZ' for your session Source-Connect Pro: Changing your receive port:...
- Page 7 Source-Connect Network Configuration For further support: Chicago: +1 312 706 5555 London: +44 20 7193 3700 support@source-elements.com This document is designed to assist IT/Network administrators to configure your network to allow Source-Connect traffic in and out of your firewalled or NAT network.
- Page 8 More technical information can be found here, if needed: http://www.source-elements.com/public Introduction to how Source-Connect works. Source-Connect transfers a real-time, high-quality audio stream between remote locations via the UDP protocol. UDP is used in order to allow low delay communication, and thus relies on network access to UDP ports. Generally, the machine running Source-Connect is on a private network address (behind NAT, or Network Address Translation).
-
Page 9: If You Have Any Questions
still possible in this case. If 'failed' it is highly unlikely that there will be sent or received audio. Common issues: Connection Test: ʻport not mappedʼ or ʻfailedʼ The user is able to properly configure their network for UDP port mapping however the connection test does not return successfully. - Page 10 VO2GO Lite Kit Inventory 1. Mac computer 2. Mac power supply 3. MBox Mini 4. 1 USB cable 5. Sound Devices MM-1 6. Pop Screens and holder 7. Pop screen mounting gooseneck 8. Pop screen gooseneck clamp 9. (1) ¼” TRS patch cable 10.
Need help?
Do you have a question about the VO2GO Lite and is the answer not in the manual?
Questions and answers