Advertisement
Quick Links
Advertisement
Summary of Contents for Miami ISSH
- Page 1 1.800.543.0448 www.miamicorp.com min. 11“ Carbon Fiber Seat Heater (ISSH) Installation Manual...
- Page 2 Index General safety advice ............. . . 2 Component list …...
- Page 3 Pre-Installation Summary – Overview 1. Remove the existing front or rear seat covers. 2. Take note of whether the covers reattach by way of Velcro or Hog rings. 3. The Wire Connector with Purple & Black colored wires is seat the connector which will enable the use of both High &...
- Page 4 2. Component list A) 2 X Carbon Fiber Heating Pads B) 1 X Illuminated Hi/Low Switch C) 1 X Wire Harness D) 1 X 5-Pin Automotive Relay E) 1 X Fuse Holder containing a 12 volt Fuse...
-
Page 5: Installation Instructions
Installation Instructions 1. Ensure that the vehicle is on a level surface in “Park” & with the hand brake engaged. 2. Disconnect the car’s battery or ensure that the work area is well grounded. 3. Unplug any wires which may be attached / harnessed to the underside of the vehicle’s seat. Proceed to unbolt the seat from the vehicle’s floor. - Page 6 Installation Instructions – Continued 14. Re-install the vehicle’s seats and attach the connector which you secured underneath the seat with the connector pulled up through the carpeting. Make sure to securely re-bolt the vehicle’s seats to the vehicle’s floor. 15. At this point connect the seat heater lead wires to the previously identified safe power source and secure a good ground base.
- Page 7 Wiring diagram...
- Page 8 Operating instructions for seat heating units - Safety advice **Warning: The seat heating unit is only allowed to be operated when a person is sitting on it. This person must be able to feel temperatures and be able to react to them. Persons who experience difficulty with feeling temperatures –...
- Page 9 Operating instructions for seat heating units – Consumer Guide “HIGH” Temperature Setting: - The seat heating system is switched ‘ON’ by pressing the switch upwards towards the Double wave located at the top of the face of the switch. This will engage the seat heater in the High temperature setting. This is confirmed by the RED color emitted by the LED light.
Need help?
Do you have a question about the ISSH and is the answer not in the manual?
Questions and answers