Vaterra Nissan Silvia V100-C Owner's Manual page 14

/ / / / / / / / / / / / / / / / / / / / / / / / / / / / / / / / / / / / / / / / / / / / / / / / / / / / / / / / / / / / / / / / / / / / / / / / / / / / / / / / / / / / / / / / / / / / / / / / / / / / /
* noTiCe: Crawler mode is for use on
rocky surfaces only. Do not use this
mode with your vehicle on any other
surface, especially pavement. Doing
so may damage the vehicle.
SMart Brake
When the throttle is changed from
Forward to Reverse or Reverse to
Forward, the ESC will brake instead
of reversing the motor immediately.
The ESC will remain in brake mode
unless the throttle is returned to the
neutral/stop position for a short time.
14
•
Power OFF the ESC and then power ON the ESC to return to normal operation.
oPeration
waiting for throttle position
neutral Flashing Green
forward Flashing Red
Solid Red / Flashing Green
full Brake/reverse
c change eSc running Mode: forward/
reverse with Smart Brake forward
only with Brake or crawler Mode
•
The green LED will indicate the
currently selected ESC running
mode for 4 seconds:
-
Green Forward/Reverse
LED Solid with Smart Brake
-
Green LED Forward Only
Flashing with Brake
-
Red + Green
LED Solid Crawler Mode*
led StatuS
position set
Solid Green (1 second)
Solid Red (1 second)
Solid Green (1 second) followed by Red and Green flashing 3x
•
Move the throttle trigger to full throttle
within the 4 seconds to select the next
ESC mode. A beep will sound and the
green LED will indicate the new ESC
running mode.
•
To select the next mode, repeat the
step above within 4 seconds of the
beep.
•
Both red and green LEDs will flash
3 times with 3 beeps.
•
Power OFF the ESC and then power on
the ESC to return to normal operation
•
At any time that the ESC is powered
and the transmitter is at neutral, the
green LED will indicate the current
running mode:
-
Green Forward/Reverse
LED Solid with Smart Brake
-
Green LED Forward Only
Flashing with Brake
-
Red + Green
LED Solid Crawler Mode*