Installation - Waterco DigiHeat 2.4kW Installation And Operation Manual

• If the adjustment required is outside the
range of this switch then a different switch
or a flow switch will be needed to protect the
heater.
• Stop and start the pump several times
to check the correct operation. Repeat if
necessary.
• Replace front cover on DigiHeat.

INSTALLATION

DigiHeat single phase models can be mounted directly onto the pipework, fixed to a wall or base
mounted. Wall and base fittings are supplied.
Digiheat three phase units can be mounted directly onto the pipework or fixed to a wall.
Wall fittings are supplied with the unit.
Direct mounting onto pipework
- simply connect the Digiheat to the pipework. Ensure
the pipework is rigid and secure.
wall mounting
- use the 4 small mounting brackets supplied.
Slide two small mounting brackets into the channel
located on the top of the Digiheat and the same on the
bottom.
base mounting
– use the 2 large mounting brackets supplied
(single phase model only).
Slide two large mounting brackets into the channel
located on the bottom of the DigiHeat
large mounting brackets
pressure switch adjustment screw
small mounting brackets
THE TOUCH PAD
1. Digital display. Displays the water temperature, bias setting and fault codes.
2. On/Off button. Used to switch the Digiheat On or Off.
3. Up arrow button.
Used to increase the desired water temperature and also increase the
bias setting. (refer to bias adjustment section.)
4. Down arrow button.
Used to decrease the desired water temperature and also decrease
the bias setting. (refer to bias adjustment section.)
5. ˚C/ ˚F button. Use to toggle between Farenheit and Celcius.
6. ˚C indicator light. temperature displayed in ˚C
7. ˚F indicator light. temperature displayed in ˚F
1
6
7
Digiheat Touch-Pad
Waterco Digiheat In Line Heaters
I pg 05
3
5
2
4