Miele G 603 Installation Instructions Manual page 13

Dimension X must be calculated and
noted before attaching the fixing
bracket.
Dimension X is the distance shown on
the illustration between the drill hole in
the machine outer door panel and the
lower edge of the neighbouring unit
door.
^ Push the dishwasher into the recess
and adjust the height.
^ Calculate dimension X.
Fitting the fixing bracket to a door
front
^ Lay the door front down with the rear
side facing upwards. Draw a vertical
line down the middle of the door front
rear to use as a guide line.
^ Mark dimension X onto the rear of the
door front, up from the bottom edge.
With two-piece panels:
If the two-piece panel is joined by
non-flush fixings these must be
removed. The fixing bracket supplied
with the dishwasher can be used to
secure both pieces.
Make sure that the combined height
worked out is retained.
Installation
13