producTion of inflaTable boaT owner’s manual producTion of inflaTable boaT This manual has been completed to help you to operate your craft with safe- Always maintain your craft properly and make allowance for the deterioration ty and pleasure. that will occur in the time and as a result of heavy use or misuse of the craft. It contains details of the craft;...
Prepare other boat operators. Instruct at least one other per- son on board in the basics of starting and operating the outboard, and boat Before you prepare for the water with your BUSH inflatable, check the local handling, in case the driver becomes disabled or falls overboard.
3.1 The valves recommended load. Always use the seats/seating spaces provided. The BUSH valves are especially designed for safe and comfortable use. The valves are designed flat to increase the comfort in the boat and to prevent Payload.
Remove any sharp objects from flat surface where boat will be assembled. BUSH boats which are equipped with an inflatable or a non-inflatable floor To inflate the boat, roll the boat out on the floor. If the boat is unpacked, must be operated with these floors properly installed before use.
Page 6
3.8 rowinG equipmenT well under the half-inflated tubes and against the transom. The valve BUSH boats come as standard with oars, rowlocks, and a rowing seat. En- must be face up. sure seat is properly installed. To install the oars in the oarlocks, put the oars •...
• Push evenly on the whole boat to let as much air out as possible. If you deflate and store your BUSH, you can leave the inflatable floorboard as Position of the outboard engine it is installed, just leave out the air and fold the boat.
producTion of inflaTable boaT owner’s manual safeTy and operaTion recommendaTions 3.12 foldinG The boaT 4. safeTy and operaTion Put the boat on the floor. recommendaTions Take out the floorboards. Fold the boat to the middle of the boat, so that the whole boat is as 4.1 imporTanT safeTy informaTion wide as the transom.
4.3.3 Under engine power • Check the inflation pressure of the air chambers. The bottom of your BUSH is designed to have a “V” shape (except the • Remove any obstruction from the self bailer floor drain. model type S and A). This improves the sailing characteristics, especially •...
Page 10
producTion of inflaTable boaT owner’s manual safeTy and operaTion recommendaTions 4.3.4 Single Operation At all speeds it is advisable to keep the boat level. Prevent the bow from pointing up, and prevent the bow from pointing down towards the water. Use When operating under power without passengers, sit not on inflation tubes the weight of the people on board to achieve the level position.
Page 11
Towing this way makes the boat steady and secure behind the towing boat, 4.4.3 Beaching and helps to avoid damage to your BUSH. Attach the towing ropes as in the It is recommended that the boat not be powered onto the beach, dragged...
If you have any damage to your BUSH, we strongly recommend to your air pressure must be reduced at the higher altitude to prevent over inflation. refer to your BUSH dealer. If the damage is a small puncture you can use 4.4.8 Swimming the material you find in the repair kit.
Larger areas or, if the parts overlaps a seam, should be patched by a pro- front. fessional repair technician at an inflatable repair station. Contact your local BUSH dealer for the nearest inflatable repair station. • cause unnecessary noise to fellow water sporters.
7. warranTy V. Customer must provide reasonable access to the product for warranty service by delivering the product for inspection to a BUSH dealer au- thorized to service the purchaser’s product. If a purchaser cannot de- LIMITED WARRANTY liver product to such authorized dealer, the may give notice in writing We warrant each new production BUSH inflatable boat and accessories to the company.
18.4/25 S - 410 4.10 1.90 2.78 0.88 0.51 3 + keel Rigid 22/30 KAIMAN R Country Phone K - 285 R 2.85 1.32 2.00 0.60 0.36 3 + keel Rigid 3.3/4.5 K - 300 R 3.00 1.47 2.10 0.75 0.36...