Table of Contents
Advertisement
Quick Links
Advertisement
Table of Contents
Summary of Contents for AplicAir AM2O-51HPDC1
- Page 1 OWNER'S MANUAL ALPICAIR A I R C O N D I T I O N E R S MODELS: AM2O-51HPDC1 AM4O-81HPDC1 Thank you for choosing ALPICAIR air conditioners. Please read this manual attentively before starting up the unit and keep it carefully for 66129909219 future reference.
-
Page 3: Table Of Contents
In line with the company’s policy of continual product improvement, the aesthetic and dimensional characteristics, technical data and accessories of this appliance may be changed without notice. GENERAL INFORMATION CONTENTS Conformity And Range The Instructions Before Use Name of Parts Technical Data Outdoor Unit Working Temperature Range Electrical Connections... -
Page 4: The Instructions Before Use
THE INSTRUCTIONS BEFORE USE GENERAL INFORMATION WARNING When having a burning smell Never cut off or damage power The power supply must adopt or smoke, please turn off the power the special circuit that with air switch cables and control wires. If the power protection and assure it has enough cable and signal control wire were supply and contact with the service... -
Page 5: Name Of Parts
NAME OF PARTS GENERAL INFORMATION AM2O-51HPDC1: Warning Be sure to cut off the power supply before cleaning the air conditioner; otherwise electric shock might happen. Wetting of air conditioner may cause the risk of electric shock. Make sure not to wash your air conditioner in any case. -
Page 6: Technical Data
GENERA L INFORM ATION TECHNICAL DATA MODE AM2O-51HPDC1 Electrical data Electricity supply 220-240V~,50Hz Fuse or air switch Minimum power cord section Refrigerant gas(R410A) 1400 Size and clearance GENERA L INFORM ATION TECHNICAL DATA MODE AM4O-81HPDC1 Electrical data Electricity supply 220-240V~,50Hz... -
Page 7: Electrical Connections
ELECTRICAL CONNECTIONS INS TALLER AM2O-51HPDC1: 1. R emove the handle at the right side plate of the AM2O-51HPDC1 outdoor unit (one screw). Remove the cable clamp, connect the power connection cable with the terminal at the row of connection and fix Handle the connection. - Page 8 ELECTRICAL CONNECTIONS INS TALLER AM4O-81HPDC1: 1. Remove the handle at the right side plate of the An all-pole disconnection switch having a contact outdoor unit (one screw). separation of at least 3mm in all pole should be Remove the cable clamp, connect the power connection connected in fixed wiring.
-
Page 9: Installing The Outdoor Unit
INSTALLING THE OUTDOOR UNIT INSTALLER Location Use bolts to secure the unit to a flat, solid floor. Install the drain fitting and the drain hose (for When mounting the unit on a wall or the roof, make model with heat pump only) sure the support is firmly secured so that it cannot Condensation is produced and flows from the outdoor unit move in the event of intense vibrations or a strong... -
Page 10: Maintenance
When picking up and moving the units, you must be guidedby trained and qualified person. Ensure that the recommended space is left ar ound the a ppliance . AM2O-51HPDC1 50cm or more Space to the cover 30cm or above... -
Page 11: Check After Installation
CHECK AFTER INSTALLATION INSTALLER Check Items Problems Owing to Improper Installation Is the installation reliable? The unit may drop, vibrate or make noises Has the gas leakage been checked? May cause unsatisfactory cooling (heating) effect Is the thermal insulation of the unit May cause condensation and water dropping sufficient? Is the drainage smooth?
Need help?
Do you have a question about the AM2O-51HPDC1 and is the answer not in the manual?
Questions and answers