1. Manuals
  2. Brands
  3. Canyon Manuals
  4. Two-Way Radio
  5. CNR-WT3
  6. User manual

Canyon CNR-WT3 User Manual

Hide thumbs
1
2
3
4
5
6

Advertisement

Table of Contents

Article: CNR-WT3
Red LED Indicator
MENU/Power button
Talk (Push to Talk)
Mic (Microphone)
Call Button
1. LCD Screen
Transmitting a signal
Receiving a signal
Power Low indicator

2. Fitting the batteries

Your Walkie-talkie includes a rechargeable battery pack for each handset.
Step 1 To remove the belt clip
1. It's easier to fit the battery pack without the belt clip in place.
2. Pull the tab forward (away from the handset) to release the belt clip.
Then lift the belt clip off.
CANYON Two-Way Radios
USER MANUAL v1.0
Channel Number
Speaker volume level
Antenna
LCD Screen
Up/Down buttons
Scan Button
Speaker
ENG 1

Advertisement

Table of Contents
loading

Summary of Contents for Canyon CNR-WT3

  • Page 1: Fitting The Batteries

    CANYON Two-Way Radios Article: CNR-WT3 USER MANUAL v1.0 Red LED Indicator Antenna MENU/Power button LCD Screen Up/Down buttons Talk (Push to Talk) Mic (Microphone) Scan Button Call Button 1. LCD Screen Speaker Channel Number Speaker volume level Transmitting a signal...
  • Page 2 Step 2 To fit the batteries 1. Open the locking latch and slide off the battery compartment cover. 2. Insert the rechargeable battery pack as shown. Make sure the ‘UP’ arrow is showing, and pointing towards the top of the handset.

  • Page 3: Operation

    The charge light comes on when a handset is in the cradle Battery Meter The PMR can detect when the battery charge level gets low.   An alert tone will be heard and the RED LED indicator will flash once every 15 seconds.
  • Page 4 the mouth. While holding the TALK button, speak into the mic (microphone) in a normal tone of voice. 3. Release the TALK button when you have finished transmitting. Important 1. In order to receive your transmission, other people must also be on the same channel that you are currently using.

  • Page 5: Troubleshooting Guide

    1. Press the Menu button twice. 2. Press the UP or DOWN button to select High or Low. The LCD Screen will display "L" when the low power is selected. At low power mode, the PMR will transmit at reduced transmitting range but could extend the battery life. 3.
  • Page 6 Cannot To change channels, press the Menu button once then press change the UP or DOWN buttons to change the current channel. channels. Batteries may be weak. Range is Batteries may be weak. limited. Replace with new batteries if the battery charge level is low.

Table of Contents