MODEL7304 User Manual 1. 1. 1. 1. Introduction Introduction Introduction Introduction MODEL7304 is a high-performance V.35 optic fiber modem developed by using a dedicated integrated circuit. It is to modulate a N×64K V.35 data signal directly over single- or multi-mode optic fiber for a transmission via optic cable line. At another end of the optic cable, optical signal is demodulated into a V.35 data signal.
MODEL7304 User Manual Rack-mountable: 19in 4.5U standard casing Power Power Power Power supply supply supply supply: Independent:85V~264V AC input, 5V/2A output -36V~-72V DC input , 5V/2A output Rack-mountable:150V~260V AC input,5V/16A ,12V/1A output -38V~-58V DC input,5V/16A ,12V/1A output Power consumption: 3W Operating temperature: 0°...
MODEL7304 User Manual lamp flashes. When local device is not at a framing mode, it is unable to detect whether opposite device is at a loopback test status. PTOK:Indicator lamp of pseudo-random code test. When the device is at a loopback status, pseudo-random code test can be made.
Page 6
MODEL7304 User Manual Select the number of time slots according to the expected rate. Normally for an independent type, a time slot setting of automatic tracking Central Site module is selected. Coded switches of plate-clip time slot correspond to S1, S2, S3 and S4. Rear Rear Panel...
MODEL7304 User Manual � � � � RACK/DC RACK/DC redundancy power supply panel RACK/DC RACK/DC DC DC redundancy redundancy redundancy power power power supply supply supply panel panel panel: RACK/DC RACK/DC RACK/DC RACK/DC DC DC Redundancy Redundancy Redundancy Redundancy Power Power Power Power Supply...
MODEL7304 User Manual RXD B receiving data line B output EXTCLK exterior clock line A input EXTCLK exterior clock line B input receiving clock line RXCL A output receiving clock line RXCL B output transmitting clock TXCL A output line A transmitting clock TXCL B...
MODEL7304 User Manual Local main timing (S5.1=ON, S5.2=ON): the sending timing is of local crystal OSC, and the received data, after buffering, is synchronized with local timing. 5.3.2 5.3.2 Phase Phase selection selection 5.3.2 5.3.2 Phase Phase selection selection S5.4 is used for the receiving phase selection of V.35 interface. 5.3.3 5.3.3 Settings...
MODEL7304 User Manual V.3 5 Fiber Link V.3 5 Fiber Modem V3 5 Fiber Modem V3 5 Local R e m o te pseudo-random Code Test pseudo-random pseudo-random pseudo-random Code Code Code Test Test Test Remark: Remark: Remark: Pseudo-random sequence code test can be made only under a loopback status. At Remark: this moment, constantly lightening of LOOP and PTOK/CRC lamps shows local status, flash shows remote status;...
MODEL7304 User Manual 6. 6. 6. 6. Common Common Problems Common Common Problems Problems Problems Common Common Failures Failures Solutions Solutions Common Common Failures Failures and and Solutions Solutions No. Failure Cause Solution power supply 1.Power supply not properly 1.Check power switch jack...