Advertisement
ADC Mobile Car Show Installation Guide – GM Series
Unplug factory radio
harnesses
Carefully unplug all
harnesses at back of the
.
factory radio
CONFIGURE REQUIRED CABLES
Set up the right harnesses for your vehicle
Factory GM Connectors (L-R): X4 / X3 / X2 / X1
installation, and we suggest mounting it in the FACTORY location (see GPS mounting diagrams below or visit our online
tech support to determine the location and method of mounting GPS antenna)
Bluetooth microphone: If you are planning on using the Car Show Bluetooth system, we HIGHLY recommend using the
external microphone (PP1011)
USB: On systems that already have a factory USB port, the Car Show USB input will plug directly into the factory USB
cable. On systems that DO NOT have a factory USB port, you must add an optional mini-male USB to standard female
USB cable or a factory USB receptacle in order for USB to function.
Camera: If you are replacing a factory navigation system and have a factory installed rear view camera, or have the factory
camera display in the mirror, the camera may be used on the GM1210. However, the GM1210 does not come with an
adaptor to allow a plug and play connection. See our online instructions for hooking up the factory camera.
The Car Show GM1210 comes with all of the harnesses to replace almost all types of factory systems. In order to configure
your combination of components and harnesses correctly, refer to the following chart.
ADC Mobile Car Show GM1210 Multi-Media Navigation System Installation Guide
NON-BOSE TRUCKS
Factory Plugs: The picture at left shows a typical plug
arrangement in a GM vehicle – depending on your trim level
and factory installed accessories, your vehicle may or may
not have all of these plugs present. Use this photo as a guide
for the proper use of the Car Show connectors.
The colors of these plugs may vary:
X1: BLACK
X2: BLACK or YELLOW
X3: GRAY or BLACK
X4: BROWN
Main Harness: Car Show Main Harness plugs into factory
X1 & X2 connectors. Car Show XM/OnStar output harness
plugs into BLACK port on radio and UART harness plugs into
BROWN port on radio. The Main Harness is pre-configured
for Non-Bose systems. If you are installing into a Bose
system, you will need to disconnect the main harness
speaker connector (this has PINK label on it) and use the
PP-GM1210-8 harness as outlined below.
GPS Antenna: You will use the GPS antenna in every
BOSE TRUCKS/SUV'S
STEP 3
Page 5
Advertisement
