Advertisement
Advanced programming in system mode (for experts only)
- press shift and one of the left four hotcue keys to reset the corresponding setup to the factory settings
- Display scales converts incoming data (range 0 – 127) to specific display indications
- LED bar mode selection works directly with Traktor (controls modifier 8)
- Shift key sends also a command which controls modifier 7 in Traktor
that's necessary for all pots / faders as a condition in Traktor's assignment table.
- all keys and encoders send different commands by holding shift (second layer)
- Filter mode 'spreaded' has a finer resolution around center position to optimize the whole pot range
- Filter mode 'double command' makes it possible to control two filters with the same pot in Ableton Live
to simulate a bipolar filter like in Traktor
- Pot mode 'same commands' makes it possible to use deck and FX pots / faders without parameter jumps,
that works with same commands for the pots / faders independent from deck / slot selections,
the deck / slot selections send also commands for modifier control (M1 to M4) as a condition
for pots and faders in Traktor's assignment table
- Pot mode 'different commands' makes it possible to work with each kind of software because all pots and
faders send different commands depending on deck / slot selection and shift (used in Ableton live setup)
- in Key mode 'toggle' all key LEDs will be controlled directly in the device in addition
- Global controls to channel 2 is useful for a setup with two DJ44 so the second unit can control
different things with global controls in the right section and the crossfader
- you can choose between 2 EQ modes for different EQ center values:
value 63 as most used standard and value 108 for EQ three in Ableton live
- 2 Encoder modes are available:
'absolute' - all encoders work like standard pots
'relative' - all encoders send incremental / decremental data (used in Traktor and Live setups)
Command specifications (for experts only)
- please use a midi monitoring software to get all the command codes if necessary
- all controls send CC data (control change) except the keys in key mode 'note command'
- most LEDs are controlled by feedback data with the same commands as the corresponding keys
(except deck, FX and bank select which are only controlled directly in the controller)
- following midi channels are in use:
channel 1: Deck A / FX slot 1 / global controls / crossfader
channel 2: Deck B / FX slot 2 / global controls / crossfader
channel 3: Deck C / FX slot 3 / LED bar mode
channel 4: Deck D / FX slot 4
- additional commands:
LED bar: CC88 (for LED bar mode 1 to 5)
LED bar: CC22 (for LED bar mode 6 to 7)
Play-LED blinking: CC89 (track end warning)
Loop-LED: CC84
Loop-LED blinking: CC90 (is in active loop)
LED bar mode 1 to 8: CC92 to CC99 (Modifier 8 control)
Display: CC26
Display (shift): CC27
Advertisement
