Band Switch; Search Stations; Direct Frequency Input; Memory Presets - ANJAN DTS-01 User Manual

Band switch :

Press the Band button to select different band in the following order : FM – AM – SW .

Search Stations :

1. Manual Search : Press - or + button continuously to locate the station.
2. Auto Search : Press - or + button for 0.5 seconds , the radio will carry auto search and stop at the
next station.
3. Memory Recall : Select the band. Press the numeric button 0-9 to recall the required channel.

4. Direct Frequency Input :

(i) Select the band.
(ii) Press the Freq. Input AM/FM button.
(iii) Within 5 seconds, press the numeric buttons to set the frequency.
(iv) Press the Freq. Input AM/FM button to confirm.
Examples :
1. FM 104.7 MHz : Press Band button, Freq Input FM , then 1-0-4-7 and Freq Input FM button
again
2. AM 567 KHz : Press Band button, Freq Input AM , then 5-6-7 and Freq Input FM button again
3. SW 6.125MHz : Press Band button, Freq Input AM , then 6-1-2-5 and Freq Input FM button
again
(The tuning step for FM=0.1 MHz, AM=9k/10k, SW=0.005MHz)
Memory Presets ( 3 x 10 presets) :
1. Use auto, manual or direct frequency input to locate the station.
2. Press the M button , the LCD indicator will blink.
3. Press the numeric buttons 0-9 to store into the selected channel.
4. Press the M button again to confirm.

Wake-to-Radio

1. Alarm Time Setting - Press the AL button once, the alarm icon will blink for 3 seconds. Press the +
button to set the hour and – button to set the minute.
2. Turn off alarm function – Press the AL button, you will see the previous preset time blinking. Press
the AL button again. The alarm icon will disappear.
2