Page 1
Read the operator's manual and follow all warnings and • Customer Responsibilities safety instructions. Failure • Service and Adjustments to do so can result in seri- ous injury. • Repair Parts Sears, Roebuck and Co., Hoffman Estates, IL 60179 U.S.A. 530-084009 (8/11/95)
Keep firm footing and balance at all • Use only genuine replacement parts as recommended by times. SEARS to avoid creating a hazard and/or voiding your war- • Never place objects inside the blower tubes; always direct the ranty.
Page 3
SAFETY RULES Ii.. WARNING This power unit can be dangerous! This unit can cause serious injury or blindness to the operator and others. The warnings and safety instructions in this manual must be followed to provide reasonable safety and efficien- cy in using this unit.
For two (2) years from date of purchase, when this Gas Blower is maintained, lubricated, and tuned up according to the instructions in the owner's manual, Sears will repair, free of charge, any defects in material or workmanship. This warranty excludes blower tubes, spark plug and air cleaner, which are expendable parts and become worn during normal use.
Page 5
These accessories and attachments were available when the unit was originally purchased. They are also available at most Sears retail outlets and service centers. Most Sears stores can order these items for you when you provide the model number of your unit.
Flare Nozzle Blower Tube ...., " '_r E+!;£,: 3.2 oz. :;s:~;';'":> 40:1 Operator's Manual 2-Cycle Engine Oil Parts packed separately in carton 358.798980 ..,..00 __ ..= ~lIXln .3.2 oz. rx8.W~¥:~"Cn 40:1 ir.?·':.~;·:; 2-Cycle Operator's Manual...
Page 7
ASSEMBLY VACUUM TUBE ASSEMBLY HOW TO ASSEMBLE YOUR BLOWER (Fig. 2 & r>... WARNING • Remove the blower tube from the engine. Stop the engine before opening the vacuum • Set the unit, blower outlet up, on a flat surface. Open the inlet door or attempting to insert or remove the vacuum inlet cover as follows: vacuum tubes.
Page 8
ASSEMBLY VACUUM BAG ASSEMBLY (Fig. 4, 5, 6 & 7) • Open the zipper on the large end of the vacuum bag. • Insert the elbow tube, grooved end first, through the zip- per opening in the vacuum bag. Then, push the grooved Elbow end of the elbow tube through the vacuum bag tube Curved...
Page 9
OPERATION KNOW YOUR BLOWER (Fig. 8) READ THIS OPERATOR'S MANUAL AND SAFETY RULES BEFORE OPERATING YOUR BLOWER. Compare the illus- trations with your unit to familiarize yourself with the location of the various controls and adjustments. Save this manual for future reference.
Page 10
OPERATION HOW TO USE YOUR BLOWERNAC PRIMER BULB • The primer bulb is used to circulate fuel to the carburetor. STOPPING YOUR ENGINE • The primer bulb is activated by pressing on it with your thumb. • Move ignition switch to the "STOP" position. •...
Page 11
• When using the unit as a vacuum, always use the shoul- Instructions in the manual before operating. der strap to avoid loss of control. • Always wear a respirator or facemask when working in • Use only quality SEARS accessories and replacement dusty environments. parts as recommended for this unit.
Page 12
• Vary the air flow by adjusting your grip on the throttle trig- ger. Do not use the unit as a vacuum without the • While using the model 358.798980 use the assist handle vacuum tube vacuum properly...
Page 13
CRAFTSMAN 40:1 2-cycle engine oil (AIR-COOLED) specially blended with fuel stabilizers. If you do not use this Sears oil, you can add a fuel stabilizer (such as CRAFTS- MAN No. 33500) to your fuel tank.
Page 14
OPERATION STOPPING YOUR ENGINE • Move the choke lever to the "Half Choke" position. • Pull the starter rope sharply until the engine runs, but no • Move the ignition switch to the "Stop" position. more than six pulls. • If engine does not stop, move the choke lever to the "Full If the engine still has not started, it is probably flooded.
CUSTOMER RESPONSIBILITIES MAINTENANCE SCHEDULE Service Dates Every Yearly After Before Fill in dates as you complete regular service 5 Hrs. Check for damaged or worn parts Check for loose fasteners & parts Clean unit & labels Clean air filter Replace spark plug Replace fuel filter BEFORE USE GENERAL RECOMMENDATIONS...
Page 16
CUSTOMER RESPONSIBILITIES EVERY 5 HOURS YEARLY CLEAN AIR FILTER (Fig. 15) (Fig. 16) REPLACE SPARK PLUG 1">.. The spark plug should be replaced each year to ensure the CAUTION engine starts easier and runs better. To avoid creating fire hazard and producing harmful emissions, do not clean filter in gasoline Spark plug gap should be .025", or other flammable solvent.
Page 17
CUSTOMER RESPONSIBILITIES (Fig. 17 REPLACE FUEL FILTER & The fuel filter should be replaced after each season. Never operate your unit without a fuel filter. Be careful not to dam- age fuel line while removing the fuel filter. • Run fuel tank dry of fuel before proceeding with this step. •...
Page 18
SERVICE AND ADJUSTMENTS STARTER ROPE (Fig. 19, 20, 21,22, 23, 24 & • Remove the 5 screws from the pulley housing, then remove the pulley housing and pulley from the engine . .Ii.. WARNING Do not remove the pulley when replacing the starter rope.
Sears cannot deny warranty solely for the lack of receipts or for your failure to ensure the performance of scheduled maintenance. the lawn and garden equipment engine owner, you should be aware that Sears may deny you warranty coverage your...
Page 20
Sears servicing center. CONSEQUENTIAL DAMAGES-- Sears may be liable for damages to other engine components caused by the failure of a warranted part still under warranty. WHAT IS NOT COVERED-- failures caused by abuse, neglect, or improper maintenance are not covered.
Page 21
AND ADJUSTMENTS SERVICE 3/16"- " Rope Tai Figure 23 Figure 24 • Guide rope inside the pulley, then through pulley hole. • Align the hole in the impeller with the impeller shaft, mak- Figure 23. ing sure the flat sides are aligned. •...
Page 22
SERVICE AND ADJUSTMENTS Very small aqjustments can affect engine performance. It is CARBURETOR ADJUSTMENTS important to make slight ajustments and test performance Carburetor adjustment is critical and If done Improperly before proceeding. Each adjustment should be no more than can permanently damage the engine as well as the car- 1/16th of a turn.
Page 23
If you do not use this heaters, electric motors or switches, furnaces, Sears oil, you can add a fuel stabilizer (such as CRAFTS- etc. MAN No. 33500) to your fuel tank.
Page 24
4. Contact your SEARS Service Center/Dept. 4. None of the above. /( situations occur which are not covered in this manual, use care and good judgement. /( you need assistance, contact your SEARS Service Center/Department or the CUSTOMER ASSISTANCE HELPLINE at 1-800-235-5878.
Page 26
530-069714 Fan Housing Kit 530-029728 Cover-Air Filter & (lncl. #71,73-77,79,86 105) 530-029112 Air Filter 530-027569 Starter Handle 530-047754 Assist Handle - Model 358.798980 530-015769 Screw Muffler 530-069293 530-047782 Cap - Model 358.798960 Spring 530-029116 Muffler Guard 530-030075 Spark Plug 530-069303...
Page 27
REPAIR PARTS Carburetor Assembly Part Number 530-069730 (WA219-B) Carbo Repair Part Description 530-069729 Carburetor Repair Kit 530-038403 Limiter Cap-Single Needle Vacuum Tube/Blower Tube Ass'y. PART NO. KEY NO. DESCRIPTION 530-095358 Collection Bag 530-037250 Shoulder Strap 530-069750 Vacuum Tube 530-038555 Tube & Nozzle Ass'y. 530-095359 Vac Tube Stand...
Page 28
Each Gas Blowers' has its own model number. The model number for your unit will be found on a decal attached to the unit. All parts listed herein may be ordered from any Sears, Roebuck IFYOU NEED REPAIR and Co. Service Center and most Retail Stores.
Need help?
Do you have a question about the 358.798980 and is the answer not in the manual?
Questions and answers