Table of Contents
Advertisement
BATTERIES & MAINTENANCE
Battery Replacement:
Your HEADHUNTER PIRATE metal detector operates
with two, 9-volt standard batteries (batteries supplied).
Hourly use can be extended by using 9V Alkaline batteries.
To add or replace batteries on the PIRATE, place a
coin into the slot on the earcup and turn until the cup
"pops" open exposing the battery compartment. Note the
placement of the worn batteries before removal. Remove
the old batteries and insert two fresh 9-Volt batteries into
the connectors.
This earcup is O-ring sealed. Be sure to carefully clean
the O-ring, the groove it resides in and the mating halves
of the earcup. Lubricate O-ring sparingly with silicone
grease only. DO NOT USE PETROLEUM JELLY.
After batteries have been installed, carefully align the
earcup halves and press until a solid "snap" is heard. Make
sure battery connector wires are well inside of the seal
area and do not get pinched on reassembly.
Maintenance:
1. Always thoroughly rinse your HEADHUNTER
PIRATE in fresh water after using it in salt water.
2. Store your detector in a cool place.
3. Never store it in a manner that it will be subject to
vibration or shock.
8
Advertisement
Table of Contents
