Net Wan Mode Configure - D-Link DSR-150 Reference Manual

Unified Services Router
4 Username
5 Passw ord
6 Dial_number
7 AuthMethod
8 Apn
9 Reconnect_mode
10 Idle_time
11 Get_dns_from_isp
12 Primary_dns
13 Secondary_dns

8.33 net wan mode configure

S.No Com mand Nam e
1 save
2 cancel
3 exit
4 w an_mode_type
5 loadbalancing
6 loadbalancing algo
7 loadbalancing failover_method
8 loadbalancing spillover
loadbalancing spillover
9
load_tolerance
loadbalancing spillover
10
max_bandw idth
loadbalancing failover_method
11
type
Enter the username required to log in to
the ISP.
Enter the passw ord required to login to
the ISP
Enter the number to dial to the ISP
Select one of None, PAP or CHAP
Authentication Protocols to connect to
the ISP
Enter the APN(Access Point Name)
provided by the ISP
Select Alw ays On: The connection is
alw ays on OR On Demand :The
connection w ill close after time specified
in Idle_time field
The connection is automatically ended if
it is idle for a specified number of minutes idle timeout value type.
Enter Yes to get dns dynamically from
ISP if you have not been assigned any
static IP address. The ISP w ill
automatically assign an DNS address to
the router using THREEG netw ork
protocol. Otherw ise Enter No and give
valid static dns addresses
Valid primary DNS Server IP Address
Valid secondary DNS Server IP Address
Description
Save w an mode configuration changes.
Roll back ipv4 w an configuration
changes.
Save w an mode configuration changes
and current mode.
Select among the options:
SINGLE_WAN, LOAD_BALANCING,
AUTO_ROLLOVER
If Mode Type selected is
LOAD_BALANCING, this field gives you
options to configure LOAD_BALANCING
credentials
Enter the type of LoadBalancing Algo
Select the Fail Over detection method
Spill Over Configuration Parameters
Percentage of max bandw idth after whi c h
the router sw itches to secondary WAN
Sets the maximum bandw idth tolerable
by the Primary WAN.If the bandw idth
goes below the load tolerance value of
configured Max Bandw idth, the router
sw itches to secondary WAN.
Select the Fail Over detection method
57
CLI Reference Guide
String
String
String
THREEG Authentication Types.
String
ISP Connectivity Types.
Boolean choice
IP address AAA.BBB.CCC.DDD
w here each part is in the range 0-
255
IP address AAA.BBB.CCC.DDD
w here each part is in the range 0-
255
Type and Description
Types of WAN modes
Types of Loadbalancing algorithms
Unsigned integer
Unsigned integer
Types of Faillover Detection