Troubleshooting - JVC HR-XV28S Instructions Manual

Troubleshooting (Continued)
Symptom
The DVD+VCR does not
start playback.
Video tape cannot be
inserted.
No Hi-Fi sound
No NICAM sound
recording
The remote control does
not work properly.
Timer recording is not
possible.
38
Cause
• An unplayable disc is inserted.
• The disc is placed upside down.
• The disc is not placed within the guide.
• The disc is dirty.
• The Rating level is set.
• Is the cassette compartment empty?
• Audio mode is not set properly.
• NICAM mode is not set properly.
• There is an obstacle in the path of the
remote control and this unit.
• The batteries in the remote control are
exhausted.
• The remote control is not pointed at the
remote sensor of the DVD+VCR.
• The remote control is too far from the
DVD+VCR.
• This remote control use the same buttons
for VCR and DVD functions (ex.PLAY).
• Clock in DVD+VCR is not set to correct
time.
• Timer has been programmed incorrectly.
• indicator light does not appear after
programming timer.
Correction
• Insert a playable disc. (Check the disc
type and Regional code.)
• Place the disc with the playback side
down.
• Place the disc on the disc tray correctly
inside the guide.
• Clean the disc.
• Cancel the Rating function or change
the rating level.
• Eject the tape in.
• Select STEREO by repeatedly pressing
AUDIO on the remote control.
• Make sure NICAM in the menu is set to
AUTO for the station to be recorded.
• Remove the obstacle.
• Replace the batteries with new ones.
• Point the remote control at the remote
sensor of the DVD+VCR.
• Operate the remote control within 23ft
(7 m).
• When using a VCR, first press the VCR
button. When using a DVD, first press
the DVD button.
• Set clock to correct time.
• Reprogram Timer.
• Reprogram Timer and turn DVD+VCR
off to enable timer.