D-Link DWL-3500AP Configuration Manual page 29

14. Create Rule 3 to allow all other type of traffic between any source and any destination
since as mentioned earlier, there is an implicit "deny all" rule at the end of every ACL.
15. From the Rule drop-down menu, select Create.
16. Enter 3 into the Rule ID field, Permit into the Action field, and True in the Match
Every field, and then click Submit.
Next, you must attach the ACL to port 0/1 and port 0/13 so that the rules are applied to
the appropriate wireless client traffic that goes through the APs connected to the switch.
1. From the ACL
2. Select port 0/1 from the Slot/Port drop-down menu.
3. Select IP ACL as the ACL Type.
4. Enter 1 as the sequence number, and click Submit.
5. Repeat the steps to associate ACL 100 with port 0/13.
Interface Configuration page,