Advertisement
Quick Links
GPS Vehicle Tracking Unit
Installation Guide
Note to Installer - Please return
these instructions to customer
for future reference
Installation Support:
866-658-1191
support@streeteagle-gps.com
Precautions
12v DC Power only.
The Vehicle Tracking Unit (VTU) is designed for
negative ground 12V DC systems only. Do not use the
VTU with any other power systems.
Do not disassemble or modify the VTU.
This could cause electric shock, personal injury or fire.
Do not connect power from a different system to the
VTU. When in doubt of a safe installation, please
contact your local installer.
Do not install VTU in locations that interfere with
airbag operation.
This could cause a risk of accidents and injury.
Use only specified fuse.
When replacing the fuse, please ensure the amp rating
is the same as the previous fuse.
Cautions
Do not let wires get punctured by screws or caught in
moving parts.
Turn car ignition off before making connections.
Connect the Red and White power input leads after all
other connections have been made.
Use a common ground point for all ground wires.
Tape and insulate any loose unconnected wires.
Note on power wire (Red)
When connecting VTU in combination with other electric
devices, be sure the vehicles' circuit amp rating is higher
than the sum of each component's fuse.
Advertisement
Subscribe to Our Youtube Channel
Summary of Contents for StreetEagle VTU
-
Page 1: Installation Guide
This could cause electric shock, personal injury or fire. Do not connect power from a different system to the VTU. When in doubt of a safe installation, please contact your local installer. Do not install VTU in locations that interfere with airbag operation. -
Page 2: Installation Procedures
The VTU should be mounted in the dash, unobstructed by metal and with a direct line of sight to the sky. Please ensure that the VTU’s GPS Side is facing the sky. This is marked by a sticker on the VTU, showing “GPS THIS... - Page 3 After all of the lights are solid turn the vehicle off, then turn it back on and verify the installation. Note: When the VTU is installed, it can take up to 20 minutes for the GPS to acquire its position after initial power-up.
-
Page 4: Troubleshooting
Solution - Verify proper installation of unit; verify that the VTU has a clear view of the sky, with the proper side up Ping – Requests for the tracking unit to send its current location and status.
Need help?
Do you have a question about the VTU and is the answer not in the manual?
Questions and answers