Basic Operations; Turning On/Off The Player; Initial Setup - JVC XV-NP1SL Instructions Manual

Basic operations

STANDBY indicator
NOTE
Make sure that the TV - DVD switch on the
remote control unit is set to "DVD" when
TV DVD
using the 5/∞/2/3 and numeric buttons
for controlling the player.
About invalid operation icon
When you press a button, and if the player does not accept its
operation, appears on your TV screen. Operations are
occasionally unacceptable even if
Note that some operations may not be accepted. For example,
some discs may not allow rapid advance/reverse or slow-
motion playback.

Turning on/off the player

Press DVD STANDBY/ON
control unit or press
The STANDBY/ON indicator on the front panel, which lights
in red during standby, lights in green.
The left and right sides of the display window are illuminated.
The opening display appears on the TV screen, and the following
messages may appear at the bottom of the opening display.
NOW READING
Message area
• NOW READING (The player is reading the disc information.)
• REGION CODE ERROR! (The region code of the DVD VIDEO
disc does not match the player. The disc cannot be played
back.)
• CANNOT READ THIS DISC
8
0 7 3
is not displayed.
on the remote
on the front panel.
• OPEN
• CLOSE
• NO DISC
NOTES
• Even if you turn off the player, the player is not disconnected
from the AC power source as long as it is connected to the wall
outlet. This state is called standby mode. In this state, the player
consumes a very small amount of power.
• You can change the picture of the opening display. (See page
25.)

Initial setup

You can set the display language, TV monitor type and digital
output before using the player, by following the procedure below.
1
Press CHOICE for a few seconds to bring up
the first page of the DVD PLAYER SET UP
display.
The pull-down menu of the [ON SCREEN LANGUAGE] is
already open.
DVD PLAYER SET UP
MENU LANGUAGE
AUDIO LANGUAGE
SUBTITLE
ON SCREEN LANGUAGE
SELECT USE 5∞23 TO SELECT, USE ENTER TO CONFIRM
ENTER
ON SCREEN LANGUAGE options
2
Press 5/∞ to select the desired language.
You can select the on-screen language for the preference
displays, etc. from among ENGLISH, FRENCH, and
SPANISH.
3
Press ENTER.
The second page is shown, in which the pull-down menu of
the [MONITOR TYPE] is already open.
DVD PLAYER SET UP
MONITOR TYPE
PICTURE SOURCE
SCREEN SAVER
BACKGROUND
SELECT USE 5∞ TO SELECT, USE ENTER TO CONFIRM
ENTER TO EXIT, PRESS CHOICE
MONITOR TYPE options
4
Press 5/∞ to select the desired monitor type.
For a normal (conventional) TV, select [4:3 LB] or [4:3 PS].
For a wide-screen TV, select [16:9]. (See page 27.)
ENGLISH
ENGLISH
OFF
ENGLISH
ENGLISH
FRENCH
SPANISH
4:3 L.B.
16:9
AUTO
4:3 LB
4:3 PS
ON
MP3