Burcam 300403h Installation Instructions Manual

Emergency battery pump
Hide thumbs Also See for 300403h:

Advertisement

2190 Boul. Dagenais West
LAVAL (QUEBEC)
CANADA
H7L 5X9
Your unit has been carefully packaged
at the factory to prevent damage
during shipping. However, occasional
damage may occur due to rough
handling. Carefully inspect your
pump for damages that could cause
failures. Report any damage to your
carrier or your point of purchase.
W W W. B U R C A M . C O M
TEL: 514.337.4415
FAX: 514.337.4029
info@burcam.com
INSTALLATION
45
0
ELECTRICAL PUMP
AND PIPING NOT
INCLUDED
© 2007 BUR-CAM Printed in Canada
MODEL
300403H
EMERGENCY
BATTERY
PUMP
Please read
these instructions
carefully. Failure
to comply to
instructions and
designed
operation of
this system,
may void the
warranty.
310674

Advertisement

Table of Contents
loading
Need help?

Need help?

Do you have a question about the 300403h and is the answer not in the manual?

Questions and answers

Summary of Contents for Burcam 300403h

  • Page 1 2190 Boul. Dagenais West TEL: 514.337.4415 LAVAL (QUEBEC) FAX: 514.337.4029 MODEL CANADA H7L 5X9 info@burcam.com 300403H Your unit has been carefully packaged EMERGENCY at the factory to prevent damage BATTERY during shipping. However, occasional PUMP damage may occur due to rough Please read handling.
  • Page 2 INSTRUCTIONS: (applicable to your electrical primary pump) This fine pump that you have just purchased is designed from the latest in material and workmanship. Before installation and operation, we recommend the following procedures CHECK WITH YOUR LOCAL ELECTRICAL AND PLUMBING CODES TO ENSURE YOU COMPLY WITH THE REGULATIONS.
  • Page 3 APPLICATION FEATURES Designed for a permanent installation on 12 V DC motor a submersible or column type sump pump. Easy to install on any kind of sump pump. CAPACITY: Check valve included. 4’ 1 400 US GPH FRICTION LOSS 8’ 1 200 US GPH An electrical outlet is required.
  • Page 4: Installation Steps

    INSTALLATION STEPS NOTICE Installation of this unit may take several hours. Before disabling your main pump, have ready appropriate means of evacuating the sump. Turn off power to main pump. STEP 1 Check valve : If you install your emergency 12 V pump using the same STEP 2 discharge pipe of your main 115V pump, a check valve is required between the T or Y connection and both pumps.
  • Page 5 Reducer 1” to 1 1/4” 14 52258 90° Elbow 15 350353 1 1/4” check valve 16 310665 AC Adaptor 17 310664 Control box Model 300403H 2007 18 310668 Big head screws (4) 19 310671 Battery cable clamp FOR INFORMATION TEL: 514.337.4415 FAX: 514.337.4029...
  • Page 6 T R O U B L E S H O O T I N G G U I D E C H E C K L I S T NEVER MAKE ADJUSTMENTS TO ANY ELECTRICAL APPLIANCE OR PRODUCT WITH THE POWER CONNECTED. DON’T JUST UNSCREW THE FUSE OR TRIP THE BREAKER, REMOVE THE POWER FROM THE RECEPTACLE.

Table of Contents