Button Descriptions - Sony Trinitron KV-40XBR700 Service Manual

Introducing the FD Trinitron Wega

Button Descriptions

1
2
3
4
5
6
7
8
9
q;
qa
qs
z
To scan rapidly through the
channels, press and hold down the
CH+ or CH- button.
4
The following table describes the buttons on the remote control that
are for more advanced functions.
Button
1 MUTING
2 SLEEP
qd
qf
qg
3 DISPLAY
qh
4 ANT
5 JUMP
qj
6 DRC/
CINEMOTION
qk
7 PIC MODE
ql
w;
8 MENU
9 VOL +/-
q;
qa GUIDE
qs RESET
qd POWER buttons
(GREEN)
qf FUNCTION
buttons
Description
Press to mute the sound. Press again or press VOL + to
restore the sound.
Press repeatedly until the TV displays the time in
minutes (15, 30, 45, 60, or 90) that you want the TV to
remain on before shutting off automatically. Cancel
by pressing until SLEEP OFF appears. While Sleep
feature is set, press once to view remaining time.
Press once to display the current time and channel
label (if set) and channel number. Press again to turn
Display off. See page 46 for details on setting the time.
Changes between the VHF/UHF input to the AUX
input.
Press to jump back and forth between two channels.
The TV alternates between the current channel and
the last channel that was selected.
For high quality sources (i.e., DVD player, Satellite
Receiver), this button cycles through the available
high-resolution picture modes: Interlaced, Progressive,
Cinemotion. Also available in the Video menu. For
details, see "Selecting Video Options" on page 36.
Cycles through the available video picture modes:
Vivid, Standard, Movie, Pro. Also available in the Video
menu. For details, see "Selecting Video Options" on
page 36.
Press to display the TV on-screen menu. Press again
to exit from the menus.
Adjusts the volume.
Joystick allows for movement of the on-screen cursor.
Pressing down on the center of the joystick selects the
item.
Displays the satellite program guide.
Press when in a menu to reset the settings to the
factory defaults.
Turn on and off the TV and SAT/CABLE equipment
you have programmed into the remote control. For
instructions, see "Programming the Remote Control"
on page 50.
Select the equipment (TV or SAT/CABLE) that you
want to operate. The indicator lights up momentarily
when pushed to show which device the remote
control is operating.